Woodstock W1694 Avoiding Potential Injuries, Never surface plane without push blocks

Page 10

Avoiding Potential Injuries

SAFETY

Figure 1. Correct operator and workpiece position, guard is in place, and push blocks are being used.

Figure 2. Never surface plane without push blocks!

Figure 3. Never stand directly behind

the workpiece!

Figure 4. Never plane/edge-joint with	Figure 5. Never joint end grain!
the guard removed!	-8-
	-8-

Image 10

Contents Bench TOP Jointer Page Contents Introduction Woodstock Service and SupportAbout Your New Jointer Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocksGrounding Electrical Requirements110V Operation Extension CordsUnpacking AssemblyInventory Shop Preparation Initial CleaningDust Collection To attach the rubber feet, do these steps Rubber FeetFence Support To attach the fence support, do these stepsFence Assembly To assemble the fence assembly, do these stepsDust Port To install the 90˚ stop slide, do these steps90˚ Stop Slide To connect the dust port to a trash can, do these stepsTo connect the dust port to a trash bag, do these steps Assembling the trash bag supportAdjustments FenceTo adjust the 90˚ angle stop, do these steps Fence Angle StopsTo adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these stepsBlade Height To check the cutterhead blade height, do these stepsTo adjust the depth of cut Depth Of CutBlade Guard Blade guard in useTest Run OperationsTo test run the Model W1694, do these steps Operation Requirements Correct and incorrect grain Alignment to cutterheadSurface Planing To perform a surface planing operation, do these stepsEdge Jointing To perform an edge jointing operation, do these stepsBevel Cutting To perform a bevel cutting operation, do theseTable Surface MaintenanceGeneral Sharpening BladesReplacing Blades To replace the cutterhead blades, do these stepsLubrication Guard SpringTo replace a worn out blade guard spring, do these steps Motor Brushes Drive BeltsTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.8 Kb

Avoiding Potential Injuries

Figure 1. Correct operator and workpiece position, guard is in place, and push blocks are being used.

Figure 2. Never surface plane without push blocks!

Figure 3. Never stand directly behind

the workpiece!

Figure 4. Never plane/edge-joint with

Figure 5. Never joint end grain!