Woodstock W1694 instruction manual Maintenance, General, Table Surface, Sharpening Blades

Page 29

MAINTENANCE

General

Regular periodic maintenance on your Model W1694 will ensure its optimum performance. Make a habit of inspecting your machine each time you use it. Check for the following condi- tions and repair or replace when necessary:

•Loose mounting bolts.

•Worn switch.

•Worn or damaged cords and plugs.

•Any other condition that could hamper the safe operation of this machine.

Table Surface

Tables can be kept rust-free with regular appli- cations of products like SLIPIT®. For long term storage you may want to consider products like Boeshield T-9™. Whichever product you ulti- mately choose for a table lubricant, make sure that it protects against rust, allows the work- piece to slide easily and will not stain expensive workpieces.

Sharpening Blades

Correct blade sharpening and honing techniques are beyond the scope of this manual. Have the blades professionally sharpened for the best results.

Make sure that your machine is unplugged during any maintenance procedures except where instructed other- wise! If this warning is ignored, serious person- al injury may occur.

-27-

MAINTENANCE

Image 29

Contents Bench TOP Jointer Page Contents About Your New Jointer Woodstock Service and SupportIntroduction Specifications Warranty and ReturnsStandard Safety Instructions Safety#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Never surface plane without push blocks Avoiding Potential Injuries110V Operation Electrical RequirementsGrounding Extension CordsInventory AssemblyUnpacking Dust Collection Initial CleaningShop Preparation Fence Support Rubber FeetTo attach the rubber feet, do these steps To attach the fence support, do these stepsTo assemble the fence assembly, do these steps Fence Assembly90˚ Stop Slide To install the 90˚ stop slide, do these stepsDust Port To connect the dust port to a trash can, do these stepsAssembling the trash bag support To connect the dust port to a trash bag, do these stepsFence AdjustmentsFence Angle Stops To adjust the 90˚ angle stop, do these stepsTo adjust the 45˚ outward angle stop bolt, do these steps To adjust the 45˚ inward angle stop bolt, do these stepsTo check the cutterhead blade height, do these steps Blade HeightDepth Of Cut To adjust the depth of cutBlade guard in use Blade GuardTo test run the Model W1694, do these steps OperationsTest Run Correct and incorrect grain Alignment to cutterhead Operation RequirementsTo perform a surface planing operation, do these steps Surface PlaningTo perform an edge jointing operation, do these steps Edge JointingTo perform a bevel cutting operation, do these Bevel CuttingGeneral MaintenanceTable Surface Sharpening BladesTo replace the cutterhead blades, do these steps Replacing BladesTo replace a worn out blade guard spring, do these steps Guard SpringLubrication To replace the drive belts, do these steps Drive BeltsMotor Brushes Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.8 Kb