Woodstock W1694 Edge Jointing, To perform an edge jointing operation, do these steps

Page 27

Edge Jointing

Edge jointing straightens the concave edge of the workpiece (Figure 34). This straight edge can then be guided along the rip fence of a table saw when squaring rough lumber. The straight, flat edge is also used for gluing up large panel assemblies.

Figure 35 shows an example of an operator edge jointing. Notice that the operator’s body is not directly in line with the workpiece and that he maintains a stable hand position while keeping the workpiece firmly on the table and against the fence.

To perform an edge jointing operation, do these steps:

1.Read and become familiar with the Operation Requirements sub-section.

2.Place the workpiece so the concave edge is down on the infeed table and press the workpiece firmly against the fence.

3.Start the jointer.

4.Feed the workpiece through the jointing operation. Make sure to maintain even downward pressure.

5.If your leading hand gets within 4" of the cutterhead, lift it up and over the cutter- head and place it on the workpiece as it passes over the outfeed table. Do the same thing when your trailing hand gets within 4" of the cutterhead and try to maintain pres- sure on the outfeed table.

6.Repeat steps 4-5until the edge is flat.

Portion

Removed With

Jointer

Figure 34. Edge jointing straightens the concave

edge of the workpiece.

ALWAYS wear safety glasses to prevent seri- ous personal injury!

Figure 35. This is an example of an edge

jointing operation.

OPERATIONS

-25-

Image 27

Contents Bench TOP Jointer Page Contents Woodstock Service and Support IntroductionAbout Your New Jointer Specifications Warranty and ReturnsStandard Safety Instructions Safety#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Never surface plane without push blocks Avoiding Potential InjuriesExtension Cords Electrical Requirements110V Operation GroundingAssembly UnpackingInventory Initial Cleaning Shop PreparationDust Collection To attach the fence support, do these steps Rubber FeetFence Support To attach the rubber feet, do these stepsTo assemble the fence assembly, do these steps Fence AssemblyTo connect the dust port to a trash can, do these steps To install the 90˚ stop slide, do these steps90˚ Stop Slide Dust PortAssembling the trash bag support To connect the dust port to a trash bag, do these stepsFence AdjustmentsFence Angle Stops To adjust the 90˚ angle stop, do these stepsTo adjust the 45˚ outward angle stop bolt, do these steps To adjust the 45˚ inward angle stop bolt, do these stepsTo check the cutterhead blade height, do these steps Blade HeightDepth Of Cut To adjust the depth of cutBlade guard in use Blade GuardOperations Test RunTo test run the Model W1694, do these steps Correct and incorrect grain Alignment to cutterhead Operation RequirementsTo perform a surface planing operation, do these steps Surface PlaningTo perform an edge jointing operation, do these steps Edge JointingTo perform a bevel cutting operation, do these Bevel CuttingSharpening Blades MaintenanceGeneral Table SurfaceTo replace the cutterhead blades, do these steps Replacing BladesGuard Spring LubricationTo replace a worn out blade guard spring, do these steps Drive Belts Motor BrushesTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.8 Kb