Woodstock W1694 Drive Belts, Motor Brushes, To replace the drive belts, do these steps

Page 32

MAINTENANCE

Drive Belts

To replace the drive belts, do these steps:

1.Lay the jointer on its side so the switch is facing up.

2.Remove the bottom cover.

3.Loosen the screws securing the motor mount plate and the impeller mount plate (Figure 44).

4.Adjust the mounting plate to allow the drive belts to loosen.

5.Remove the drive belts.

6.Replace or re-install the drive belts, making sure they are aligned correctly.

7.Replace the bottom cover.

Motor Brushes

To replace the drive belts, do these steps:

1.Lay the jointer on its side so the switch is facing up.

2.Remove the bottom cover.

3.Using a flat-head screwdriver, remove the motor brush caps (Figure 45).

4.Replace the motor brushes if they are dam- aged or severely blackened by carbon build- up.

5.Re-install the motor brush caps.

6.Replace the bottom cover.

-30-

Figure 44. Motor and impeller

mount plate screws.

Figure 45. Motor brush caps.

Image 32

Contents Bench TOP Jointer Page Contents About Your New Jointer Woodstock Service and SupportIntroduction Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocksElectrical Requirements 110V OperationGrounding Extension CordsInventory AssemblyUnpacking Dust Collection Initial CleaningShop Preparation Rubber Feet Fence SupportTo attach the rubber feet, do these steps To attach the fence support, do these stepsFence Assembly To assemble the fence assembly, do these stepsTo install the 90˚ stop slide, do these steps 90˚ Stop SlideDust Port To connect the dust port to a trash can, do these stepsTo connect the dust port to a trash bag, do these steps Assembling the trash bag supportAdjustments FenceTo adjust the 90˚ angle stop, do these steps Fence Angle StopsTo adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these stepsBlade Height To check the cutterhead blade height, do these stepsTo adjust the depth of cut Depth Of CutBlade Guard Blade guard in useTo test run the Model W1694, do these steps OperationsTest Run Operation Requirements Correct and incorrect grain Alignment to cutterheadSurface Planing To perform a surface planing operation, do these stepsEdge Jointing To perform an edge jointing operation, do these stepsBevel Cutting To perform a bevel cutting operation, do theseMaintenance GeneralTable Surface Sharpening BladesReplacing Blades To replace the cutterhead blades, do these stepsTo replace a worn out blade guard spring, do these steps Guard SpringLubrication To replace the drive belts, do these steps Drive BeltsMotor Brushes Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.8 Kb