Woodstock W1694 Replacing Blades, To replace the cutterhead blades, do these steps

Page 30

MAINTENANCE

Replacing Blades

To replace the cutterhead blades, do these steps:

1.UNPLUG THE JOINTER!

2.Use a 61⁄4" wide piece of wood to prop the blade guard open.

3.Remove the four blade clamping screws on one of the blades (Figure 38).

4.Remove the blade and clamp from the cut- terhead.

5.Slide the replacement blade and clamp into the cutterhead.

6.Place a straightedge across the outfeed table and over the top of the cutterhead blade.

7.At both ends of the cutterhead, the straightedge must make contact with the blade (Figure 39). Watch and make sure the straightedge is not lifted from the out- feed table surface when contact is made with the cutterhead blades.

•If the straightedge makes contact on both ends of the cutterhead blade, then continue to step 9.

•If the straightedge does not make con- tact with both ends of the cutterhead blade, then continue to the next step.

8.Adjust the jack screws under the blade until both ends of the cutterhead blade make contact with the straightedge (Figure 40).

9.Retighten the four blade clamping screws loosened in step 3 and repeat steps 3-7on the second blade.

10.Remove the wood that is holding the blade guard open.

-28-

Figure 38. Blade clamping screws.

Figure 39. Checking the blade height.

Figure 40. Jack screws.

Image 30

Contents Bench TOP Jointer Page Contents Woodstock Service and Support IntroductionAbout Your New Jointer Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Avoiding Potential Injuries Never surface plane without push blocksGrounding Electrical Requirements110V Operation Extension CordsAssembly UnpackingInventory Initial Cleaning Shop PreparationDust Collection To attach the rubber feet, do these steps Rubber FeetFence Support To attach the fence support, do these stepsFence Assembly To assemble the fence assembly, do these stepsDust Port To install the 90˚ stop slide, do these steps90˚ Stop Slide To connect the dust port to a trash can, do these stepsTo connect the dust port to a trash bag, do these steps Assembling the trash bag supportAdjustments FenceTo adjust the 90˚ angle stop, do these steps Fence Angle StopsTo adjust the 45˚ inward angle stop bolt, do these steps To adjust the 45˚ outward angle stop bolt, do these stepsBlade Height To check the cutterhead blade height, do these stepsTo adjust the depth of cut Depth Of CutBlade Guard Blade guard in useOperations Test RunTo test run the Model W1694, do these steps Operation Requirements Correct and incorrect grain Alignment to cutterheadSurface Planing To perform a surface planing operation, do these stepsEdge Jointing To perform an edge jointing operation, do these stepsBevel Cutting To perform a bevel cutting operation, do theseTable Surface MaintenanceGeneral Sharpening BladesReplacing Blades To replace the cutterhead blades, do these stepsGuard Spring LubricationTo replace a worn out blade guard spring, do these steps Drive Belts Motor BrushesTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.8 Kb