Woodstock W1694 instruction manual Blade Guard, Blade guard in use

Page 23

Blade Guard

The blade guard protects the operator from the cutterhead blades. It must be functioning cor- rectly before performing any jointing operation.

To make sure the blade guard is functioning correctly, do these steps:

1.UNPLUG THE JOINTER!

2.Adjust the infeed table even with the out- feed table.

3.Slide a piece of wood across the jointer as if performing an actual jointing operation.

•The blade guard should rotate enough to allow the wood to pass over the cutter- head (Figure 30).

•Once the wood has passed over the cut- terhead, the blade guard should swing completely back over the cutterhead.

4.Swing the blade guard completely open and release it.

•The blade guard should swing complete- ly back over the cutterhead.

Figure 30. Blade guard in use.

ADJUSTMENTS

-21-

Image 23

Contents Bench TOP Jointer Page Contents About Your New Jointer Woodstock Service and SupportIntroduction Specifications Warranty and ReturnsStandard Safety Instructions Safety#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Never surface plane without push blocks Avoiding Potential InjuriesExtension Cords Electrical Requirements110V Operation GroundingInventory AssemblyUnpacking Dust Collection Initial CleaningShop Preparation To attach the fence support, do these steps Rubber FeetFence Support To attach the rubber feet, do these stepsTo assemble the fence assembly, do these steps Fence AssemblyTo connect the dust port to a trash can, do these steps To install the 90˚ stop slide, do these steps90˚ Stop Slide Dust PortAssembling the trash bag support To connect the dust port to a trash bag, do these stepsFence AdjustmentsFence Angle Stops To adjust the 90˚ angle stop, do these stepsTo adjust the 45˚ outward angle stop bolt, do these steps To adjust the 45˚ inward angle stop bolt, do these stepsTo check the cutterhead blade height, do these steps Blade HeightDepth Of Cut To adjust the depth of cutBlade guard in use Blade GuardTo test run the Model W1694, do these steps OperationsTest Run Correct and incorrect grain Alignment to cutterhead Operation RequirementsTo perform a surface planing operation, do these steps Surface PlaningTo perform an edge jointing operation, do these steps Edge JointingTo perform a bevel cutting operation, do these Bevel CuttingSharpening Blades MaintenanceGeneral Table SurfaceTo replace the cutterhead blades, do these steps Replacing BladesTo replace a worn out blade guard spring, do these steps Guard SpringLubrication To replace the drive belts, do these steps Drive BeltsMotor Brushes Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA

Related manuals

Manual 44 pages 48.8 Kb