Glossary of Terms (continued)
Regulator
A control that adjusts the line pressure to the proper amount needed to operate spray guns and air tools.
Tank Pressure Gauge
Indicates tank pressure in psi.
Line Pressure Gauge
Displays the current line pressures. It is regulated by the regulator knob.
Specific psi at which a compressor starts and stops while refilling the air tank.
Unpacking and Checking Contents
1.Remove the air compressor from the carton.
2.Place the compressor on a secure, stationary work surface and look it over carefully.
!WARNING:
Do not operate unit if damaged during shipping, handling or use. Damage may result in bursting and cause injury or property damage.
NOTICE:
THIS UNIT CONTAINS NO OIL! Follow lubrication instructions before operating compressor.
!WARNING:
For your own safety, never operate unit until all assembly steps are complete and until you have read and understood the entire operator’s manual.
!WARNING:
To reduce the risk of injury, if any parts are missing, do not attempt to operate the air com- pressor until the missing parts are obtained and installed cor- rectly.
Installation
1.Check and tighten all bolts, fittings, etc., before operating compressor.
2.Operate compressor in a ventilated area so that compressor may be properly cooled.
3.Compressor should be located where it can be directly plugged into an out- let. An extension cord should not be used with this unit.
4.To avoid loss of power and overheat- ing, additional air hose must be used to reach work area instead of exten- sion cords.
11