Power Supply and Motor Specifications

Motor Specifications and Electrical Requirements

!WARNING:

To reduce the risk of electrical hazards, fire hazards or damage to the tool, use proper circuit protection. Your tool is wired at the factory for operation using the voltage shown. Connect tool to a power line with the appropriate voltage and a 15- amp branch circuit. Use a 15- amp time delay type fuse or cir- cuit breaker. To reduce the risk of shock or fire, if power cord is worn or cut, or damaged in any way, have it replaced immedi- ately.

The A-C motor used on this compressor is a capacitor start, capacitor run non- reversible induction type, having the fol- lowing specifications. It is wired at the factory for operation on 110V-120V AC, 60 Hz service.

Voltage	110-120	220-240
Amperes	15.0	7.5
Hertz (Cycles)	60
Phase	Single
RPM	3450

General Electrical Connections

!DANGER:

To reduce the risk of electrocu- tion:

1.Use only identical replace- ment parts when servicing. Servicing should be per- formed by a qualified techni- cian.

2.Do not use in rain or where floor is wet. This tool is intended for indoor residen- tial use only.

!WARNING:

Do not permit fingers to touch the terminals of plug when installing or removing the plug to or from the outlet.