Assembly
Attaching Leveling Feet
1.From the loose parts bag find the following items:
4 Leveling feet
8 Hex nut
2.From the loose parts find the following items:
4 Leg
3.Put a hex nut on each of the leveling feet and screw it down towards the rubber foot.
4.Put the leveling feet through the holes in the bottom of each leg.
5.Put another hex nut on each of the leveling feet and hand tighten until they are next to the bottom support of the leg.
WARNING: To reduce the risk of injury from unex- pected saw or work movement, leveling feet must be adjusted so that saw does not rock. After the band saw has been attached to the legset, it will be necessary to adjust the leveling feet so the saw does not rock.
Hex Nut 3/8-16
Leveling Foot
Leg
Leg
Hex Nut
Leveling Foot
Assembling Leg Set
1.From the loose parts bag find the following hardware: 40 Carriage Bolts M8 x
40 M8 Washers
40 M8 Lockwashers
40 M8 Nuts
2.From the loose parts find the following items:
4Legs (With Attached Leveling Feet)
2Stiffeners (short)
2Stiffeners (long)
1Stand top
3.Place stand top upside down on a level surface. Fas- ten four legs to top using carriage bolts, washers, lock washers, and nuts, as shown (with nuts and washers to the inside). Note: Legs fasten to outside of top. Do not tighten at this time.
4.Fasten two long stiffeners and two short stiffeners to stand legs using carriage bolts, washers, lockwashers, and nuts, as shown. Finger tighten only at this time.
Bolt Carriage Washer M8 | Lockwasher | Nut Hex M8 |
M8 x | M8 | |
|
|
Legs
Stand Top
| Stiffener (Long) | Stiffener (Short) | |||||||
|
|
|
|
| M8 | ||||
|
|
|
| Lockwasher | |||||
|
|
|
| M8 |
|
|
|
|
|
Carriage |
|
|
| Washer | M8 Nut |
|
| ||
|
|
| |||||||
|
|
| |||||||
|
|
|
|
| |||||
Bolt |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |
Leg 
Stiffener (Long) | Stiffener |
| (Short) |
Stand Top
10