Getting to Know Your Band Saw
|
| 15 Motor |
10 Upper | 1 Warning Label | Pulley Cover |
| ||
|
| |
Cover |
|
|
6 Blade Guard
Support
Adjustment Knob
16 Blade Hangers
4 Blade Guides |
18 |
Switch | 5 |
|
|
|
|
|
|
| |
| Bearings |
|
|
|
|
| 7 Tilting | 2 Blade Tension | |
|
| Table | ||
|
| Knob | ||
|
|
|
| |
|
|
| 8 Table Tilt | 17 Model |
|
|
| ||
| 9 Tilt Table Lock Knobs | |||
14 Motor | Stops |
| 3 Blade Tracking | Nameplate |
13 Lower |
|
| ||
|
| Adjustment Knob |
|
Blade Guard
12 Sawdust
Ejection Port
11Lower
Cover
1.Warning Label
2.Blade Tension Knob - Clockwise rotation of the knob will increase the tension on the blade. Counter- clockwise rotation of the knob will decrease the ten- sion on the blade.
3.Blade Tracking, Adjustment Knob - Turn knob to adjust blade tracking.
4.Blade Guides - The guides are adjustable to provide full support of the blade.
5.
6.Blade Guard Support Adjustment Knobs - Loosen this knob to vertically adjust the blade guard support so that it just clears the workpiece to be cut. Always adjust the guard/support before turning on the band saw. Tighten the knob to lock the guard/support in the proper location.
7.Tilting Table - Table tilts for angular cuts. Use the table tilt scale under table to measure angular set- tings.
8.Table Tilt Lock Knobs - Loosen knobs to move tilt table to required angle. Retighten knobs to secure table.
9.90° Table Stops - Ensures table is perpendicular to blade.
10.Upper Cover - Pull knob to expose upper wheel dur- ing blade changes.
11.Lower Cover - Pull knob to gain access to lower wheel, remove the blade or to clean out sawdust
12.Sawdust Ejection Port - Your band saw is equipped with a vacuum hookup. This feature will allow you to attach any standard
WARNING: Sawdust can clog motor. Motor could ignite sawdust. Even if saw is connected to vacuum, blow out sawdust regularly from motor.
13.Lower blade guard. Safeguards user from acciden- tal blade contact.
14.Motor.
15.Motor pulley cover.
16.Blade Hangers - Extra blades may be stored here.
17.Model nameplate.
16