Winegard TN2300-DV setup guide To enter Configuration Mode, To change the Lock Code

Page 5

Many device configuration settings require you to enter Configuration Mode – the device’s programming mode – before you may input the commands.

To enter Configuration Mode:

•Press <lock code> .

You will hear a steady tone indicating that you have entered Configuration Mode. When you press any additional key, the tone will stop.

If you correctly enter a configuration sequence for any of the settings listed, the steady tone will return and the TN2300-DV SERIES will have accepted the new setting. If you do not enter a valid sequence, you will hear three brief ascending tones followed by the steady tone (at which point you may re-enter your configuration settings).

To exit Configuration Mode, simply hang up the phone.

Changing the Lock Code

Your TN2300-DV SERIES is preconfigured with a lock code for use in entering Configuration Mode and to use with the Call Barring feature. The default lock code is the last four digits of the phone number.

(If no number is programmed, the default is 0000).

You may use Configuration Mode to change your lock code to any 4-digit number.

To change the Lock Code:

• From Configuration Mode, press <old lock

code><new lock code> <new lock code> .

(For example, to change the default lock code from 0000 to 5555, press

You may change multiple settings during a single Configuration Mode session. If you enter an incorrect sequence during a Configuration Mode session, only the setting you were entering will need to be re-entered; all previous changes will be retained.

The TN2300-DV SERIES volume setting allows you to adjust the volume three levels from the default setting. The adjusted volume setting remains in effect for future calls until it is manually changed. When the TN2300-DV SERIES’ power is turned Off and On, the default mid-range volume setting is restored.

Audio Line Level

 

Ver. 1.6

 

8/3/2009

- 5 -

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Connection via Wall Jacks Direct Connection PhoneTo make a call Using the TN2300-DV SeriesMaking Calls To place a call on hold To access your voicemail using Direct DialTo retrieve a call on hold To answer a call waiting callTo make a three-way call To increase the phone’s volume levelTo decrease the phone’s volume level To change the Lock Code To enter Configuration ModeTo change the auto-send delay To adjust your phone system’s audio line levelTo enable Zero Delay Dialing default setting To disable Zero Delay DialingTo set the Call Restrict table entries To disable Call Barring default settingTo set the Call Restrict level To enable the Hotline feature To disable Dial Tone After Remote DisconnectTo disable the Hotline feature default setting To enable One-Minute AlertsTo set the default voicemail number To set your phone’s TTY modeTo set #86 as the default voicemail number To set *86 as the default voicemail numberRestore User Defaults = Keep Current Settings and 1 = Restore to Default SettingsTo receive a fax 1-time fax mode To send a fax 1-time fax modeTo set your device to Always fax mode To make one voice call while in Always fax mode
Top Page Image Contents