Winegard TN2300-DV To adjust your phone system’s audio line level, To change the auto-send delay

Page 6

If using and does not provide satisfactory volume options for you (see “Volume Level” on page 12), you may adjust your phone system’s audio line level.

To adjust your phone system’s audio line level:

• From Configuration Mode, press <0, 1, or

2> .

0 = Low

1 = Normal (default)

2 = High

Auto-Send Delay

The auto-send delay is the amount of time the TN2300-DV SERIES waits to dial after you make an entry on the

phone keypad. The default setting is 3 seconds and the valid range is 2-20 seconds.

To change the auto-send delay:

• From Configuration Mode, press < 2 -

20> , where you enter a number between 2 and 20 seconds. (For example, if you want the auto send delay to be

five seconds, press .)

Frequently Dialed Numbers (Zero Delay Dialing)

If you dial a phone number twice and stay connected for at least 15 seconds, the TN2300-DV SERIES will remember that phone number in the future and automatically send it without the auto-send delay whenever you subsequently dial the number. This feature is enabled by default.

To enable Zero Delay Dialing (default setting):

• From Configuration Mode, press .

To disable Zero Delay Dialing:

• From Configuration Mode, press .

Call Barring

To avoid inadvertent service charges, you may enable your device’s Call Barring feature to bar all outgoing calls (except emergency calls).

To enable Call Barring:

Ver. 1.6

 

8/3/2009

- 6 -

Image 6
Contents Direct Connection Phone Connection via Wall JacksUsing the TN2300-DV Series Making CallsTo make a call To retrieve a call on hold To access your voicemail using Direct DialTo place a call on hold To answer a call waiting callTo increase the phone’s volume level To decrease the phone’s volume levelTo make a three-way call To enter Configuration Mode To change the Lock CodeTo enable Zero Delay Dialing default setting To adjust your phone system’s audio line levelTo change the auto-send delay To disable Zero Delay DialingTo disable Call Barring default setting To set the Call Restrict levelTo set the Call Restrict table entries To disable the Hotline feature default setting To disable Dial Tone After Remote DisconnectTo enable the Hotline feature To enable One-Minute AlertsTo set your phone’s TTY mode To set the default voicemail numberRestore User Defaults To set *86 as the default voicemail numberTo set #86 as the default voicemail number = Keep Current Settings and 1 = Restore to Default SettingsTo set your device to Always fax mode To send a fax 1-time fax modeTo receive a fax 1-time fax mode To make one voice call while in Always fax mode