Leica 788472 manual Measuring Functions, Measuring single distance, Add / Subtract

Page 8

Measuring Functions

Measuring single distance

1

2

3

Aim active laser at target.

8.532 m

EN

Target surfaces: Measuring errors

ican occur when measuring to col- ourless liquids, glass, styrofoam or semi-permeable surfaces or when aiming at high gloss surfaces.

Against dark surfaces the measur- ing time increases.

Permament / Minimum-Maximum measuring

1

2 sec

min.

2

max.	The minimum and maximum dis-
max.	tance measured is displayed (min,
	max.). The last value measured is
	displayed in the main line.

3

Stops permanent / minimum- maximum measuring.

Used to measure room diagonals (maximum val-	8.532 m
ues) or horizontal distance (minimum values)

Add / Subtract

1

7.332 m

2

The next meas-	The next meas-
urement is added	urement is sub-
to the previous	tracted from the
one.	previous one.

3

7.332 12.847

m m

The result is shown in the main line and the measured value

iabove. This process can be re- peated as required. The same process can be used for adding or subtracting areas or volumes.

Leica DISTOTM E7400x 788480a	7

Image 8

Contents Leica Distotm E7400x Original laser distance meterTable of Contents Instrument Set-up Introduction OverviewWhen battery Display Insert batteriesBle use, do not BatteriesSwitching ON/OFF Clear Adjusting measuring reference / tripodOperations Press button 2 sec and ref- i erence fromMultifunctional endpiece Distance unit setting Tilt unit settingTimer automatic release Beep ON/OFF Illumination ON/OFF Keypad lock on Keypad lock OFFMeasuring Functions Measuring single distancePermament / Minimum-Maximum measuring Add / SubtractArea Partial MeasurementsVolume Triangular area Aim laser at first Aim laser at secPythagoras 3-point Aim laser at upper pointAim laser at lower point Result is shown in the main AbovePoint Tangular point Pythagoras partial heightAim laser at 2nd Stake out Smart Horizontal Mode Height trackingAim laser at tar- get Up to 360 and a transverse tilt of ±10Memory 20 last displays Delete Memory Memory is completely deletedCalibration Calibration of tilt sensor Tilt CalibrationTechnical Data Tilt measurements a transverse tilt should be avoidedWarranty Safety Instructions Message CodesCare Areas of responsibilityPermitted use Prohibited useHazards in use Limits of useLabelling FCC statement applicable in U.SLaser classification