Leica 788472 manual Operations, Switching ON/OFF Clear, Adjusting measuring reference / tripod

Page 5

Operations

Message Codes

Leave actual func- tion, go to default operation mode.

If the message "InFo" appears with a number, observe the instructions in section "Message Codes".

Example:

Distance is measured from the front of the device.

Distance is measured from the tripod thread permanently.

Distance is measured from the rear of the device (standard setting).

Leica DISTOTM E7400x 788480a	4

Image 5

Contents Original laser distance meter Leica Distotm E7400xTable of Contents Introduction Overview Instrument Set-upDisplay Insert batteries When batteryBle use, do not BatteriesAdjusting measuring reference / tripod Switching ON/OFF ClearOperations Press button 2 sec and ref- i erence fromMultifunctional endpiece Distance unit setting Tilt unit settingTimer automatic release Keypad lock on Keypad lock OFF Beep ON/OFF Illumination ON/OFFMeasuring single distance Measuring FunctionsPermament / Minimum-Maximum measuring Add / SubtractPartial Measurements AreaVolume Aim laser at first Aim laser at sec Triangular areaAim laser at upper point Pythagoras 3-pointAim laser at lower point Result is shown in the main AbovePoint Tangular point Pythagoras partial heightAim laser at 2nd Stake out Height tracking Smart Horizontal ModeAim laser at tar- get Up to 360 and a transverse tilt of ±10Memory is completely deleted Memory 20 last displays Delete MemoryCalibration of tilt sensor Tilt Calibration CalibrationTilt measurements a transverse tilt should be avoided Technical DataMessage Codes Warranty Safety InstructionsCare Areas of responsibilityProhibited use Permitted useHazards in use Limits of useLabelling FCC statement applicable in U.SLaser classification