Leica 788472 manual Calibration of tilt sensor Tilt Calibration

Page 17

Calibration		EN
Calibration of tilt sensor (Tilt Calibration)
1	2	3
2 sec

simultane-

ously

Place device on absolutely flat surface.

	Turn the device horizontally by 180°			Place device on absolutely flat surface.
	and place it again on absolutely flat			Place device on absolutely flat surface.
	and place it again on absolutely flat
	surface.
				After 2 sec
		180°		the device
7	8	180°	9	i goes back to
7	8		9	i goes back to
				the normal
				mode.

Turn the device horizontally by 180° and place it again on absolutely flat surface.

Leica DISTOTM E7400x 788480a	16

Image 17

Contents Original laser distance meter Leica Distotm E7400xTable of Contents Introduction Overview Instrument Set-upDisplay Insert batteries When batteryBle use, do not BatteriesAdjusting measuring reference / tripod Switching ON/OFF ClearOperations Press button 2 sec and ref- i erence fromMultifunctional endpiece Distance unit setting Tilt unit settingTimer automatic release Keypad lock on Keypad lock OFF Beep ON/OFF Illumination ON/OFFMeasuring single distance Measuring FunctionsPermament / Minimum-Maximum measuring Add / SubtractPartial Measurements AreaVolume Aim laser at first Aim laser at sec Triangular areaAim laser at upper point Pythagoras 3-pointAim laser at lower point Result is shown in the main AbovePoint Tangular point Pythagoras partial heightAim laser at 2nd Stake out Height tracking Smart Horizontal ModeAim laser at tar- get Up to 360 and a transverse tilt of ±10Memory is completely deleted Memory 20 last displays Delete MemoryCalibration of tilt sensor Tilt Calibration CalibrationTilt measurements a transverse tilt should be avoided Technical DataMessage Codes Warranty Safety InstructionsCare Areas of responsibilityProhibited use Permitted useHazards in use Limits of useLabelling FCC statement applicable in U.SLaser classification

Calibration