Sears 113.21308 manual Removing the Chuck, Drilling to Depth, Another WAY -- Depth Scale

Page 18

REMOVING THE CHUCK

1.Open jaws of chuck as wide as they will go by turning chuck sleeve.

2.Carefully tap chuck with mallet in one hand while holding chuck in other hand to prevent dropping it when released from spindle nose,

DRILLING TO DEPTH

To drill a BLIND hole (not all the way through) to a given depth, can be done two ways.

1.Mark the depth of the hole on the side of the work- piece,

2.With the switch OFF bring the drill down until the TIP or lips are even with the Mark.

3, Spin the lower nut down to contact the depth stop lug on the Head,

4.Spin the upper nut down and tighten against the lower nut.

SLEEVE

DEPTH

STOP

MARK

/

ANOTHER WAY -- DEPTH SCALE

1.Turn the switch off.

2.Turn the feedhand_e until the pointer points to the desired depth on the depth scale.

3.Hold the feed handle at this position.

4.Spin the lower stop nut down until it touches the depth stop.

5.Spin the upper stop nut down against the lower stop nut and tighten.

6.The chuck ordrill will now be stopped after traveling downward the distance selected on the depth scale.

			DEPTH
			SCALE
	DEPTH,		UPPER
	DEPTH,	LOWER	STOP NUT
	STOP	LOWER	STOP NUT
	STOP	STOP NUT
		STOP NUT

18

Image 18

Contents Save This Manual Repair partsT3.2!3080 Part No. SP5184Full ONE Year Warranty on Craftsman Drill Press Additional safety instructions for driJl presses Protection Eyes, Hands, Face, Ears and Body Do not wearNecktie Loose clothing Jewelry RPM Right Side of the HeadDrill press is being used Contents Meter specifications and e ectricaJ requirements Connecting to Power Source OutletMotor SPECIFmCATmONS Unpacking and checking contents Description Qty Belt Tension Lock Handles HeadSupport Lock Handle ALL Assembly Steps are Completed Assembly of BASE/COLUMNInstallation of TABLE/SUPPORT Assembly and Hardware Tools NeededINSTALLiNG the Head INSTALLiNG Feed Handles INSTALLING the ChuckINSTALLING Belt Guard Knob Tensioning BeltAdjusting the Table Square to Head Adjustment Feedchuck Spring Getting to know31OORPM Insert KEY into switch Removing the Chuck Drilling to DepthAnother WAY -- Depth Scale INSTALLING Drills Basic dr!IS press operationPOSITiONiNG Table and Workpiece Tilting TableQuill Return Spring AdjustmentsHole Location FeedingAged iN ANY WAY, have IT Replaced IM MediatelyTrouble shooting Probable CauseParts List for Craftsman 8 Drill Press Model no1815 2019 Key J Part No. I No Parts LiST for Craftsman 8 Drill PressAlways order by Part Number--Not by Key Number Description Key PartKey Part Description Insert-PulleyRepair parts Parts List for Craftsman 8 Drill PressBy Key Number Part Model NO. !t3.2t3080 Partdescription