Sears 113.21308 manual Tools Needed, Assembly of BASE/COLUMN, ALL Assembly Steps are Completed

Page 10

assembly

WARNING: FOR YOUR OWN SAFETY, NEVER CON- NECT PLUG TO POWER SOURCE OUTLET UNTIL

ALL ASSEMBLY STEPS ARE COMPLETED.

TOOLS NEEDED

'['	_ ....	I	f' '1"		I'
.I,	• ], I,'I.	I	•	,	,

COMBINATION SQUARE

MEDIUM8-INCH ADJUSTABLE

SCREWDRIVERWRENCH

8mm DIA. x 20mm LONG BOLT

ASSEMBLY OF BASE/COLUMN

1.Position base on floor. Remove protective covering and discard.

2.Remove protective sleeve from column tube and discard. Place column assembly on base, and align holes in column support with holes in base.

3.Locate three (3) 8ram Dia. x 20ram long bolts among loose parts bag.

4.Install a bolt in each hole through column support and base and tighten with adjustable wrench.

INSTALLATION OF TABLE/SUPPORT

ASSEMBLY AND HARDWARE

1. Locate table/support assembly

2, Slide table/support assembly onto column. Position directly above base.

FRAMING SQUARE MUST BE TRUE.

		Check its accuracy as illustrated below.
	DRAW	LIGHT	STRAIGHT	EDGE OF
	LINE ON BOARD		BOARD 3/4" THICK--
	ALONG	THIS EDGE _. ?',_	THIS EDGE	MUST BE
			PERFECTLY	STRAIGHT
		f,÷_ •

SHOULD BE NO GAP OR OVERLAP WHEN

SQUARE IS FLIPPED OVER IN DOTTED POSITION

COLUMN

ASSEMBLY

BASE

COLUMN

TABLE/SUPPOR

ASSEMBLY

BASE

10

Image 10

Contents Save This Manual Repair partsT3.2!3080 Part No. SP5184Full ONE Year Warranty on Craftsman Drill Press Protection Eyes, Hands, Face, Ears and Body Do not wear Additional safety instructions for driJl pressesNecktie Loose clothing Jewelry Right Side of the Head RPMDrill press is being used Contents Connecting to Power Source Outlet Meter specifications and e ectricaJ requirementsMotor SPECIFmCATmONS Unpacking and checking contents Description Qty Head Belt Tension Lock HandlesSupport Lock Handle ALL Assembly Steps are Completed Assembly of BASE/COLUMNInstallation of TABLE/SUPPORT Assembly and Hardware Tools NeededINSTALLiNG the Head INSTALLiNG Feed Handles INSTALLING the ChuckINSTALLING Belt Guard Knob Tensioning BeltAdjusting the Table Square to Head Adjustment Feedchuck Spring Getting to know31OORPM Insert KEY into switch Drilling to Depth Removing the ChuckAnother WAY -- Depth Scale INSTALLING Drills Basic dr!IS press operationPOSITiONiNG Table and Workpiece Tilting TableQuill Return Spring AdjustmentsHole Location FeedingAged iN ANY WAY, have IT Replaced IM MediatelyTrouble shooting Probable CauseModel no Parts List for Craftsman 8 Drill Press1815 2019 Key J Part No. I No Parts LiST for Craftsman 8 Drill PressAlways order by Part Number--Not by Key Number Description Key PartKey Part Description Insert-PulleyParts List for Craftsman 8 Drill Press Repair partsBy Key Number Part Model NO. !t3.2t3080 Partdescription