INSTALLING Belt Guard Knob, Tensioning Belt

5ram DIA. x 12ram LONG

SCREW

BELT GUARD KNOB

iNSTALLING BELT GUARD KNOB

1, To attach belt guard knob, locate knob and 5mm Dia x 12ram _ong pan hd screw in toose parts bag. Insta!! screw in hote iocated in guard and attach knob turning until tight.

WARNING: TO AVOID POSSIBLE iNJURY KEEP GUARD IN PLACE AND iN PROPER WORKING ORDER WHILE OPERATING.

TENSIONING BELT

NOTE: The Drill Press is shipped with the bett instaited, but it should be properiy tensioned before use

1, Lift guard from right side and leave opened on hinge,

2.Release Belt Tension Lock Handle _ocated on right side of Drill Press head. Puil right side of motor toward front of driit press to refieve spring tension on belt. Tighten the belt tension lock handIe,

3.Choose speed for drilling operation, and move belt to correct position for desired speed.

NOTE: Refer to chart inside be}t guard for Recom- mended Drilling Speeds.

4.Loosen belt tension lock handle and move right side of motor rearward to apply tension to the belt,

5.Tighten Belt Tension Lock Handles.

NOTE: Belt SHOULD deflect approximately t/2" by thumb pressure at mid-point of belt between pulleys.

6. Close belt guard,

7, If belt slips while drilling, readjust belt tension.

PAN HD. SCREW

BELT GUARD KNOB

t--

I BELT 'TENSION

LOCK

HANDLE

(:::

._o

f.,,#)

1:::