Sears 113.24611 manual Assembly, Installing the Chuck, Head Lock Haindle, Packing Block

Page 6

assembly

WARNING: FOR YOUR OWN SAFETY, NEVER CONNECT PLUG TO POWER SOURCE OUTLET UNTIL ALL ASSEMBLY STEPS ARE COMPLETED.

1.Unwind the power cord.

2.Make sure the quill lock handle is tight.

3.Stand on the left side of the drill pressand LOOSEN the HEAD LOCK HANDLE.

4.Raise the HEAD about HALF WAY up the column.

CAUTION: THE HEAD WEIGHS ABOUT 70 POUNDS

DROPPING THE HEAD ACCIDENTLY COULD CAUSE PERSONAL INJURY OR DAMAGE THE DRILL PRESS.

5.TIGHTEN the Head Lock Handle.

6.Position the HEAD-SUPPORT COLLAR underneath

the head and tighten the TWO BOLTS using a 1/2 in. wrench.

HEAD

LOCK HAINDLE

	I	SPINDLE
HEAD SUPPORT		SPINDLE
HEAD SUPPORT
COLLAR	QUILL L'OCK	NOSE
COLLAR	QUILL L'OCK
	HANDLE

PACKING BLOCK

IN ORDER TO RAISE THE HEAD TO A HIGHER

POSITION, IT WILL BE NECESSARY TO INSTALL SEVERAL PARTS.

INSTALLING THE CHUCK

Clean out the TAPERED HOLE in the chuck; clean the spindle nose with a clean cloth. Make sure there are no

foreign particles sticking to the surfaces. The slightest piece of dirt on the spindle nose or in the chuck will prevent the chuck from seating properly. This will cause the drill to "wobble."

6

Image 6

Contents Sears USE Recommended Accessories General safely instructions for power toolsRemove Adjusting Keys Keep Guards in PlaceACCORDgNG to the iNSTRUCTIONS ... and Until MaintenanceATTEMPT.TO Operate Your Drbll Press Until YOU have Read and Understand the FollowingAdditional safety instructions for drill presses ContentsUnpacking and checking RPM Volts Catalog Motor specificationsEJectricaJ requirements If YOU are not Sure That Your Outlet isHead Lock Haindle AssemblyInstalling the Chuck Packing BlockFeed Handles Handle into each of the threadedHandle Place the Depth Pointer Shoe inside the pointer AssemblyInstalling the Depth Stop Loosen Quill Lock Handle ... lower the quillInstalling Motor Pulley Keyway GrooveFlat Spot Mounting the MotorBolt SleevePlug motor cord into outlet inside of dirll press Make sure the Shaft Protector is installed. NeverExcessive Tightness could Bend the Motor Mount USE the Drill Press with the Unused Shaft ExposedDrilling Speed ... Can be changed by placing INSTALLING and Tensioning BeltGetting to know your driJJ press Point within its travelSpindle Speed Chart Chuck KEYLocking Quickly Getting to know your drill pressStalls Stops Collar Chuck Sleeve Chuck KEY ROD Or DrillDR! Lling to Depth Basic drill press operationThumbscrew Another WAYHole Location Installing DrillsBasic drill press operation FeedingDiustments Depth ScaleAdiustments Pinion Backlash AdjustmentAutomatic Feed Return Adjustment LubricationCause Trouble shootingRecommended accessories WorkpieceTIO 22 21Parts List ListDrill Press Model no Parts List for Craftsman Commercial Drill Press Ball Key PartRing, Retaining, 5/8 Tube, QuillSears Model no