Sears 113.24611 manual Mounting the Motor, Bolt, Flat Spot, Sleeve

Page 10

assembly

NOTE: When using motors which have 1/2 in. dia. shafts, place the adapter sleeve (furnished with the motor) on the shaft so that the slot in the sleeve is over the flat spot.

4.Insert the shaft key (furnished with motor) into the grooves in the shaft and pulley so that the end of the key is even with the end of the shaft,

5, Tighten the set screw. Use a pair of pliers on the short end of the set screw wrench for increasedleverage.

MOUNTING THE MOTOR

1.Position the motor mount as shown and place the motor on top of it.

2, Find four 5/16 in.--18 x 3/4 in. CARRIAGE BOLTS, flat washers and hex. nuts. among the loose parts.

3.Insert the bolts as shown .,. install washers . .. screw on nuts but DON'T TIGHTEN them.

4.Using a 5/32 inch set screw wrench unscrew the PIVOT screws as shown.

3/16 x 3/16 KEY

FLAT SPOT

1/2 IN. DIA.

SLEEVE

MOTOR SHAFT

3/4 IN.

BOLT

Oplvosc :Ew

Image 10

Contents Sears USE Recommended Accessories General safely instructions for power toolsRemove Adjusting Keys Keep Guards in PlaceACCORDgNG to the iNSTRUCTIONS ... and Until MaintenanceATTEMPT.TO Operate Your Drbll Press Until YOU have Read and Understand the FollowingContents Additional safety instructions for drill pressesUnpacking and checking RPM Volts Catalog Motor specificationsEJectricaJ requirements If YOU are not Sure That Your Outlet isHead Lock Haindle AssemblyInstalling the Chuck Packing BlockHandle into each of the threaded Feed HandlesHandle Place the Depth Pointer Shoe inside the pointer AssemblyInstalling the Depth Stop Loosen Quill Lock Handle ... lower the quillInstalling Motor Pulley Keyway GrooveFlat Spot Mounting the MotorBolt SleevePlug motor cord into outlet inside of dirll press Make sure the Shaft Protector is installed. NeverExcessive Tightness could Bend the Motor Mount USE the Drill Press with the Unused Shaft ExposedDrilling Speed ... Can be changed by placing INSTALLING and Tensioning BeltGetting to know your driJJ press Point within its travelChuck KEY Spindle Speed ChartLocking Quickly Getting to know your drill pressStalls Stops Collar Chuck Sleeve Chuck KEY ROD Or DrillDR! Lling to Depth Basic drill press operationThumbscrew Another WAYHole Location Installing DrillsBasic drill press operation FeedingDiustments Depth ScaleAdiustments Pinion Backlash AdjustmentAutomatic Feed Return Adjustment LubricationCause Trouble shootingRecommended accessories WorkpieceTIO 22 21List Parts ListDrill Press Model no Parts List for Craftsman Commercial Drill Press Ball Key PartRing, Retaining, 5/8 Tube, QuillSears Model no