assembly
INSTALLING THE DEPTH STOP
| 1. Screw the THUMB SCREW partways into the DEPTH |
| POINTER. |
2. Place the DEPTH POINTER SHOE inside the pointer. | |
3. Loosen QUILL LOCK HANDLE ... lower the quill | |
| about two inches. |
4. | Slide the pointer and shoe onto the FEED STOP ROD |
| |
| and tighten the thumb screw. Make sure the pointer is |
FEED STOP
ROD
DEPTH
POINTER
DEPTH
STOP
positioned | as shown. |
SHOE
SCREW
5. | Screw the FEED STOP NUT onto the top of the feed |
| |
| stop rod. |
6.
Move the pointer upwards against the nut and tighten the thumb screvv.
7.Tighten QU_LL LOCi< HANE_LE.
QUILL LOCK
HANDLE
TABLE LOCK HANDLE
(RIGHT HAND SIDE)
RAISING THE HEAD
Z
Place a piece of WOOD on the table. USE THE packing block.
3.Turn the CHUCK SLEEVE until the jaws are all the way up inside the chuck.
4.Raise the table until the wood block touches the chuck body.
5.Tighten the Table Lock Handle.
6.Locate the two clamps and bolts that you removed
from the paper tube when you first started unpacking your drill press.
These parts make up the TABLE SUPPORT COLLAR. Position the TABLE SUPPORT COLLAR underneath the table and tighten the bolts.
7.Loosen the HEAD LOCK HANDLE.
8.Loosen the QUILL LOCK HAND LE.
QUILL LOCK
HANDLE
HEAD
LOCK HANDLE
PIECE OF
WOOD
TABLE SUPPORT
COLLAR