Sears 113.24611 manual Feed Handles, Handle into each of the threaded

Page 7

2.Apply a light film of oil such as Sears household oil to the spindle nose.

3.Place the chuck on the spindle nose and screw the locking collar up as far as it will go.

4.Insert a piece of 5/16 in. dia. STEEL ROD in to one of the holes in the chuck body.

5.Insert the CHUCK KEY into one of the holes in the

collar . . . TURN IT IN THE DIRECTION OF ARROW UNTIL IT IS TIGHT.

6.To remove chuck, turn the collar in the opposite direction until the chuck is ejected from the spindle.

CHUCK

LOCKING

COLLAR

!CHUCK SLEEVE

CHUCK KEY

5/16 IN. ROD OR DRILL

BODY

iNSTALLING	FEED	HANDLES	FEED
			FEED
1. Screw	a FEED	HANDLE into each of the threaded	HANDLE
holes in	the hub,	and tighten.

Image 7

Contents Sears Keep Guards in Place General safely instructions for power toolsRemove Adjusting Keys USE Recommended AccessoriesYOU have Read and Understand the Following MaintenanceATTEMPT.TO Operate Your Drbll Press Until ACCORDgNG to the iNSTRUCTIONS ... and UntilContents Additional safety instructions for drill pressesUnpacking and checking If YOU are not Sure That Your Outlet is Motor specificationsEJectricaJ requirements RPM Volts CatalogPacking Block AssemblyInstalling the Chuck Head Lock HaindleHandle into each of the threaded Feed HandlesHandle Loosen Quill Lock Handle ... lower the quill AssemblyInstalling the Depth Stop Place the Depth Pointer Shoe inside the pointerKeyway Groove Installing Motor PulleySleeve Mounting the MotorBolt Flat SpotUSE the Drill Press with the Unused Shaft Exposed Make sure the Shaft Protector is installed. NeverExcessive Tightness could Bend the Motor Mount Plug motor cord into outlet inside of dirll pressPoint within its travel INSTALLING and Tensioning BeltGetting to know your driJJ press Drilling Speed ... Can be changed by placingChuck KEY Spindle Speed ChartLocking Collar Chuck Sleeve Chuck KEY ROD Or Drill Getting to know your drill pressStalls Stops QuicklyAnother WAY Basic drill press operationThumbscrew DR! Lling to DepthFeeding Installing DrillsBasic drill press operation Hole LocationDepth Scale DiustmentsLubrication Pinion Backlash AdjustmentAutomatic Feed Return Adjustment AdiustmentsWorkpiece Trouble shootingRecommended accessories Cause22 21 TIOList Parts ListDrill Press Model no Parts List for Craftsman Commercial Drill Press Tube, Quill Key PartRing, Retaining, 5/8 BallModel no Sears

FEED

HANDLES

HANDLE into each of the threaded

HANDLE