10 REMOVING | AND |
| INSTALLING | SAWBLADE |
|
|
| ||||||
WARNING: | FOR | YOUR OWN SAFETY, TURN SWITCH | PULL TO LOOSEN | ||||||||||
| |||||||||||||
"OFF" | AND |
| REMOVE | PLUG | FROM POWER SOURCE | PUSH TO TIGHTEN | |||||||
QUTLET |
| BEFORE |
|
| REMOVING | OR | INSTALLING |
|
| ||||
SAWBLADEo |
|
|
|
|
|
|
|
|
|
|
|
| |
A, | Remove | insert_ |
|
|
|
|
|
|
|
| |||
B | Place |
| ARBOR |
|
| wrench | on | fiat | surfaces | of | saw |
| |
| ARBOR |
| .... | ARBOR NUT wrench on nut ,_. |
| ||||||||
| position wrenches as shown ,° hold your hands |
| |||||||||||
| well | above | blade. |
|
|
|
|
|
| ||||
C. | With | ARBOR |
| wrench against | table, | PULL | ARBOR |
| |||||
| NUT | wrench | FOREWARD | to LOOSEN nut |
|
|
| ||||||
D, | To | TIGHTEN |
|
| nut | HOLD | ARBOR | wrench |
| ||||
| against | rear |
| of | table | .... | PUSH | ARBOR | NUT |
| |||
| wrench | toward |
|
| rear, |
|
|
|
|
|
| ||
| NOTE: | When |
| installing | the | blade | make | sure | the |
| |||
| teeth are pointing toward the front of the saw |
| |||||||||||
| and that | the | blade and collars are clean, and free |
| |||||||||
| from | any | burrs |
|
|
|
|
|
|
|
| ||
The HOLLOW side of the collars must be against the blade
Always tighten the arbor nut securely,
To replace insert
FLAT SURFACESCOLLAP,
Place insert into insert opening in table and push toward rear of saw to engage spring clip and until keyslot in insert wilt drop over screw Tighten screw,
Do not tighten screw to the point where it will deflect the insert
TEETH POINTING
FRONT OF SAW
ARBOR NUT
/
11
The "yellow" plastic disc imbedded in the table in front of the sawblade, is provided for marking the location of
the "sawcut" on the workpiece
ACheck disc ,_ , if it is above table surface, place a piece of hardwood on top of it and tap it down,
B, With blade 90 ° (square to table) cut off a piece of wood
C, Pull miter gauge back until wood is over disc Using very sharp pencil, mark a line on disc,,
D, With miter gauge in right hand groove, follow same procedure and mark another line on disc
E These lines indicate the "path" of the cut (kerf) made by the sawblade,
F, When cutting the workpiece, line up mark on workpiece with line on disc,
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
/
16