ELEVATION LOCK
When correctly adjusted, the elevation mechanism is tocked
securely when the ELEVATION LOCK KNOB is approx one inch from the front of the saw,
After extended use, the ELEVATION LOCK SCREW and NUT may wear. which wl_ cause the iock to slip,
1, Tilt blade to 45 ° ,
2_ Remove retaining screw, using a 3/8 in wrench
3 Move LOCK WRENCH in the direction of the arrow {this will tighten the LOCK NUT) only enough to rep{ace the retaining screw in the next hole
4, If retaining screw is in last ho_e as shown, lift LOCK
WRENCH off of LOCK NUT and reposition it by rotating it CLOCKWISE
ELEVATION LOCK SCREW
.I
ELEVATION
LOCK NUT
ELEVATION
SCREW WRENCH LOCK KNOB
MAINTENANCE
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE MAINTAINING OR LUBRICATING YOUR SAW,
Do not allow sawdust to accumulate inside the saw.
Frequently blow out any dust that may accumulate inside the saw cabinet and the motor,
Frequently clean your cutting tools with Craftsman Gum and Pitch Remover
A coat of
allow workpieces and the fence to slide more freety.
If the power cord is worn or cut, or damaged in any way, have it replaced immediately,,
Make sure the teeth of the ANTfKICKBACK pawls are always sharp,, To sharpen:
1 Remove blade guard.
2Rotate pawl toward rear of spreader so that teeth are above top of spreader
3Hold spreader with left hand and place pawl over corner of workbench,
4, Using a small round file (Smooth | Cut) sharpen the |
teeth, | / |
26