BLADE TILT, OR SQUARENESS
OF BLADE TO TABLE
90 ° (SQUARE) and 45 ° (BEVEL) STOP COLLARS
When the bevel pointer is pointing directly to the "O" mark
on | the bevel scale, the sawblade | should | make | a SQUARE | |||
cut | 90 ° to | the | table. |
|
|
|
|
To | check | for SQUARENESS: |
|
|
|
| |
WARNING: | FOR YOUR | OWN | SAFETY, | TURN | SWITCH | ||
"OFF" AND REMOVE PLUG FROM POWER SOURCE | |||||||
OUTLET,, |
|
|
|
|
|
| |
1. | Raise | blade | al! the way | UP | raise | blade guard, | |
2.TILT b_ade a few degrees to the LEFT ..... now tilt blade back to the RIGHT as far as it will go.
3 Piace ACCURATE square against blade Make sure
square is not touching the TIP of one of the saw
TEETH.
If blade IS SQUARE to table;
A_ Check pointer
If POINTER DOES NOT point to the "O" mark on the bevel scale;
B. Loosen screw and adjust pointer , using medium screwdriver
If blade is NOT SQUARE to table . the 90 ° stop screw must be ADJUSTED
1., Unscrew 90 ° STOP SCREW three to four turns using 3/16 in setscrew wrench,
2 Tilt blade so that it is square with table.
3Screw 90 ° stop screw IN until it stops .... check once again for squareness and readjust screw, if necessary,
4, Check POINTER . readjust, if necessary.
5.Tilt blade to 45 ° and adjust 45 ° STOP SCREW the same way.
6, Check POINTER,
tf POINTER DOES NOT point to the 45 ° mark on the bevel scale.
A. Loosen the two screws and adjust bevel scale until
POINTER points to 45 ° mark on scale,
HEAD OF
COMBINATION SQUARE
POINTER
C>
90 _
_TOP SCREW 45 _
STOP SCREV_
25