Emerson CF200n100 White Ground RED, Black Blue, Ceiling Cover, Lockwasher Knurled, Flat Area

BP7354 CF200 9/19/07 11:30 AM Page 11

	STANDARD ON-OFF WALL
	SWITCH OR OPTIONAL SW101
	WALL CONTROL	BLACK
TO	BLACK
	(HOT)		BLACK
120-
VOLT			WHITE
SUPPLY	WHITE
		WHITE

GROUND	RED
TWO-CONDUCTOR	BLUE	WHITE
CABLE (WITH
GROUND)
GREEN WIRE (GROUND)	BLACK
	BLUE
FROM HANGER BALL AND	WHITE
HANGER BRACKET
Figure 17	HANGER BALL

3. Push the wires and connectors up into the outlet box while inserting the receiv- er fully into the hanger bracket. Position the antenna wire on top of the receiver.

4. Screw the two 1-1/4” threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 16).

5. Lift the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 18).

6. Secure the ceiling cover in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied). (Figure 18). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling.

CEILING

COVER

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.

7.Screw the 75-watt (maximum) halogen bulb (supplied) into the light fitter sock- et (Figure 19). Do not touch the glass bulb; use the porcelain base to screw in the bulb, or wear soft gloves.

CAUTION: To avoid risks of burns or other injury, assure power is off before attempting to install or replace the halogen bulb.

NOTICE: Do not touch halogen bulb with bare hands. Fingerprints may result in shorter bulb life. Remove fingerprints with alcohol.

LOCKWASHER

(2)

KNURLED

KNOB (2)

LIGHT	SOCKET
FITTER
PIN	75-WATT
LOWER
	HALOGEN BULB
GLASS
THREADED
STUD (2)
	FLAT AREA

Figure 18

Figure 19

11 U.L. Model No.: CF200