TOOL ASSEMBLY
Clip-LokTM System
Attaching the Belt Clip
WARNING
To reduce the risk of injury, always lock trigger or remove battery pack before changing or removing acces- sories. Only use accessories spe- cifically recommended for this tool. Others may be hazardous.
Installing the Side Handle
1.To install the side handle, loosen the side handle grip until the ring is large enough to slide over the torque selector collar. The raised rib on the side handle ring fits inside the groove around the tool. Rotate the handle to the desired position and tighten the side handle until it is secure.
The
Fig. 3 | Bit holder |
Tool holder
The belt clip can be mounted to tool belts, bags, buckets, etc. To mount the belt clip:
1.Pull up the clamp release. The clamp will pop out.
2.Slide the clamp over the tool belt, bag, bucket, etc.
3.Press in the clamp to tighten.
Using the
1. To attach the tool to the belt clip, slide |
Removing Battery Pack from Tool
Push in the release buttons and pull the battery pack away from the tool.
Inserting Battery Pack into Tool
The battery pack can be inserted into the tool in two ways. To insert the battery pack onto the tool, slide the pack onto the body of the tool. Make sure it latches securely into place.
2.To remove the side handle, loosen the side handle grip until the ring is large enough to slide off the tool.
Front tangs | Clamp |
| release |
Belt clip |
|
Stud |
|
Pin | Clamp |
|
the tool holder over the stud on the belt |
clip until it is held in place by the protrud- |
ing pin. |
2. To release the tool from the belt clip, |
grasp the tool handle, push down on |
the tool release lever with your thumb, |
and pull up on the tool. |
Using the Clip-Lok Bit Holder
The bit holder holds two standard 1/4" hex shank bits up to two inches long.
Fig. 1
For working in restricted spaces, insert the battery pack from the front of the tool.
Fig. 2
For optimum weight distribution and balance, insert the battery pack from the back of the tool.
Tool release lever
The system is shipped assembled for right- handed use. To change the assembly for
1.Remove battery pack.
2.Remove screws holding the tool holder and the bit holder.
3.Lift the holders at the narrow end and pull the front tangs out of their slots.
4.Replace the pieces onto the desired side by sliding the tangs into the slots. Tighten the screws securely.
1.Insert the bit by pressing it into the clip.
2.Remove the bit by lifting the tip of the bit and pulling it out of the clip.
6 | 7 |