2-4. Cutting Speed
The cutting speed curve shows the recommended maximum cutting speed capabilities of the power source and torch for mild steel of various thickness.
Y Exceeding recommended cutting speeds will cause rapid erosion of the tip and electrode.
Cutting speed is approximately 10 inches per minute at 0.7 in mild steel thickness at max set- ting/tip saver mode.
180 909
2-5. Selecting A Location
Movement
2 1
Location And Airflow
4
|
| 1 | Handle |
|
| Use handle to roll unit short | |
|
| distances. | |
|
| 2 | Lifting Eye |
|
| 3 | Lifting Forks |
2 |
| Use | lifting eye or lifting forks to |
|
| move unit. | |
|
| If using lifting forks, extend forks | |
|
| beyond opposite side of unit. | |
|
| 4 | Rating Label (Under Access |
| OR |
| Door) |
|
| 3 Use rating label to determine input | |
|
| power needs. | |
|
| 5 | Line Disconnect Device |
| 5 | Locate unit near correct input pow- | |
| er supply. | ||
|
| ||
|
| Y Special installation may be | |
|
|
| required where gasoline or |
|
|
| volatile liquids are present – |
|
|
| see NEC Article 511 or CEC |
|
|
| Section 20. |
18 in
(460 mm)
8 in
(203 mm)Do not block airflow around base of unit.
800 402 / Ref. 801