7-4. Adjusting Engine Speed (Kohler-Powered Units)
2000 ± 150 rpm
3720 ± 50 rpm (60 Hz)
After tuning engine, check engine speeds. See table for proper no load speeds. If necessary, adjust speeds as follows:
Start engine and run until warm.
Weld/Power Speed
Adjustment
1Throttle Control Lever
2Adjustment Screw
Move lever to Run (far right) posi- tion. To increase speed, turn screw out (counterclockwise) while lightly pushing lever to the right. To de- crease speed, turn screw in (clock- wise).
Top View
3
Idle Speed Adjustment
3 Adjustment Screw
Move lever to idle (far left) position. To increase idle speed, turn screw in (clockwise). To decrease idle speed, turn screw out (counter- clockwise).
YStop engine. Close fuel valve.
Top View
2 | 1 |
Tools Needed:
802