Hobart Welding Products 210 manual Connecting Optional Spool Gun, Appropriate setting

5-10. Connecting Optional Spool Gun

6

Spool Gun

MIG Gun

7

5

1 3 4 2

1Drive Assembly

2Spool Gun

3Gun Securing Thumbscrew

4Gun End

Loosen thumbscrew. Insert end through opening until it bottoms against drive assembly. Tighten thumbscrew.

Spool gun must be inserted completely to prevent leakage of shielding gas.

5 Gun Trigger Plug

Insert plug into receptacle, and tighten threaded collar.

6Spool Gun/MIG Gun Switch Place switch in Spool Gun position.

7Polarity Changeover Terminal Block

To make proper polarity connection, see welding power source Owner’s Manual.

. Be sure that gun end is tight against drive assembly.			Close door.
			8 Wire Feed Speed Control
	3	3	Wire feed speed is controlled by
			welding power source Wire Speed
			control (see welding power source
			Owner’s Manual or door chart for
			appropriate setting).
			9	Voltage Control
			Arc voltage is controlled by welding
			power source Voltage control (see
	Exposed O-rings		welding		power	source Owner’s
			Manual		or	door chart	for
	will cause shielding
Incorrect		Correct	appropriate setting).
	gas leakage.
			10	Trigger
Gun Not Seated		Gun Fully Seated
			Press trigger to energize welding
			power		source	contactor,	start
			shielding gas flow, and begin wire
			feed.
	9	8

10

804 695-A / 804 696-A

OM-227 978 Page 17