Model SB1020 | P R E P A R A T I O N | For Machines Mfg. Since 8/09 |
Power Connection
Electrocution or fire may occur if machine is ungrounded, incorrectly connected to power, or connected to an undersized circuit. Use a qualified electrician to ensure a safe power connection.
Once your machine is set up and assembled as previously described in this manual, it is ready to be connected to the power source.
•If you plan to use the machine at 110V, simply plug it into a receptacle on a 110V circuit that meets the requirements listed on Page 10.
•If you plan to use the machine at 220V, you will have to convert the machine for 220V. Refer to Electrical, beginning on Page 42.
Machine Setup
To ensure that your bandsaw arrives without damage to the hinge system, a shipping strap was installed. After removing the shipping strap, you may choose to install the work stop.
To set up the machine:
1.Remove the shipping strap hex bolt and strap as shown in Figure 10. Keep this shipping strap in case you transport or ship the bandsaw in the future.
Shipping Strap
Figure 10. Removing a shipping strap.
2.Thread the work stop rod into the vise base.
3.Slide the work stop onto the work stop rod, position it as necessary, then tighten the set screw shown in Figure 11.
Work Stop
Set Screw 