Grizzly G4003G owner manual Machine Labels

Page 66

Machine Labels

		1007	1002	(Place on door
	1006			of electrical box)

1005

1004

1003

1002

(Place on top of

motor junction box)

1001	1000

REF	PART #	DESCRIPTION

1000	P4003G1000	MODEL NUMBER LABEL
1001	G9987	GRIZZLY NAMEPLATE
1002	PLABEL-14	ELECTRICITY LABEL
1003	P4003G1003	DISCONNECT LABEL

REF	PART #	DESCRIPTION

1004	PLABEL-12	READ MANUAL LABEL
1005	P4003G1005	ENTANGLEMENT HAZARD LABEL
1006	PLABEL-11	SAFETY GLASSES LABEL
1007	P4003G1007	MACHINE ID LABEL

Safety labels warn about machine hazards and ways to prevent injury. The owner of this machine MUST maintain the original location and readability of the labels on the machine. If any label is removed or becomes unreadable, REPLACE that label before using the machine again. Contact Grizzly at (800) 523-4777 or www.grizzly.com to order new labels.

-64-	G4003G Gunsmith's Lathe

Image 66

Contents Model G4003G Gunsmiths Lathe Page Table of Contents Introduction ForewordContact Info Machine Data Sheet Tailstock Info Identification G4003G Gunsmiths Lathe G4003G Gunsmiths Lathe Additional Safety Instructions for Lathes Glossary of Terms 220V Single-Phase Circuit RequirementsItems Needed for Setup SetupSetup Safety UnpackingLoose Components Figure InventoryMajor Components Figure Qty Hex Wrench Set 2, 4, 5, 6, 8, 10 mm .. eaSite Considerations Clean UpPlacement Location Floor LoadTo assembly the cabinet base Mounting to ShopBolting to Concrete Floors Lifting & Moving To begin the test run & break-in procedure Test Run & Break-InTailstock Setup To align the tailstockAdjusting for tailstock end taper Spindle Speeds Operation SafetyOperation ExampleDisconnect Lathe from Power Mounting Chuck FaceplateTo install a chuck CentersSpider SpiderSteady Rest Follow Rest To use the steady restTo use the follow rest Feed Direction Lever Feed Rod LeverFeed Rate Chart Gearbox LeversHalf-Nut Lever Inch ThreadingStandard thread chart To use the chart Change Gears and Metric ThreadingCompound Slide Handwheel Carriage HandwheelsCarriage Handwheel Cross Slide HandwheelTailstock Handwheel Tool Post & HolderTailstock Controls Barrel Lock LeverAccessories Quick Change Tool HoldersH6095-Digital Readout DRO MT#3 Long Nose Center Maintenance Basic MaintenanceLubrication Slides and Ways Service TroubleshootingMotor & Gearbox Operation and Work Results Gibs Cross-slide Gib, see FigureDisconnect the Lathe from the Power Source Bearing PreloadAdjusting spindle bearings To confirm that the bearings are correctly pre- loaded Wiring-Electrical Box Electrical box wiring G4003G Gunsmiths LatheG4003G Gunsmiths Lathe Wiring-Motor & Control Panel Motor wiringG4003G Gunsmiths Lathe Wiring-Plug, Light & Spindle Switch Work light wiringG4003G Gunsmiths Lathe Parts ComponentsGearbox Gearing Gearbox Gearing Parts List Gearbox Gearbox Shifters Parts List Quick Change System Quick Change System Parts List Apron Apron Parts List Saddle Saddle Parts List Compound Slide Tailstock Lathe Bed & Motor Base Lathe Bed, Motor & Base Parts List Feed Rod Feed Rod Parts List Machine Labels Electrical Components Steady & Follow Rest Assemblies Page Page Warranty and Returns