Jet Tools JBTS-10MJS operating instructions Shipping Contents

Page 10

Shipping Contents

Unpacking

1.Remove the contents from the shipping container.

2.Compare the contents of the shipping container and hardware bags with the lists found below. Make certain that all items are accounted for before discarding any packing material. Report any shortages or damage to your JET distributor.

Contents of the Shipping Container (These items shown in Figure 3)

ABlade Guard (1)

BKickback Pawl (1)

CRiving Knife (1)

DTable Saw (1)

EPedal (1)

FMiter Gauge (1)

GStand Assembly (1)

HRear Table Extension (1)

JRear Table Extension Tube (2)

KPush Stick (1)

LRip Fence (1)

MRoller Wheel (2)

--Hardware Bags

see contents on next page

--Owner’s Manual (1)

--Warranty Registration Card

Tools Supplied for Assembly (These items shown in Figure 2)

NBlade Wrench

O4mm Hex Wrench

P5mm Hex Wrench

Figure 3 – Contents of Shipping Container

Figure 2 – Supplied Tools

Tools not included

Adjustable Wrench 6mm Hex Wrench Crosspoint Screwdriver Combination Wrench

10

Image 10

Contents Benchtop Series Model No. JBTS-10MJS Walter Meier Manufacturing IncWarranty and Service More InformationTable of Contents Page Page Table Saw Safety Specifications Definitions and TerminologyVolt Operation Only ElectricalGrounding Instructions Extension CordsFeatures FeaturesShipping Contents Hardware HardwareStand AssemblyAttaching Saw to Stand Mounting the Saw to Work Surface Rear Table ExtensionHandwheel Handle Installing the BladeRemoving the Blade Blade Guard Assembly Splitter riving knife installation FigureRip fence and miter gauge Installing the Push-stick StorageStorage Blade wrenchAdjusting the Table Insert AdjustmentsSetting up the Stand Folding the StandAligning the Blade Guard Splitter Blade Tilt Pointer 45 Positive Stop AdjustmentAdjusting the Positive Stop StopAdditional Blade Adjustments Blade Parallel to the Miter SlotAdjusting the Miter Gauge Rip Fence AdjustmentAdjusting the Locking Lever Rip Fence IndicatorRear Table Extension Adjustment Table Extension Scale PointerOperation Basic Saw OperationsCutting Operations USE the TWO AT the Same TimeRipping Small Pieces Bevel Crosscutting 0~45 Blade Level & 90 Miter AngleMitering 0~45 Miter Angle Using the Wood Facing on the Rip FenceInterfere with the cut if used on the left side groove Dado CutsPage Blade Raising and Tilting Mechanism MaintenanceLubrication Push Stick Construction Trouble TroubleshootingProbable Cause Remedy Table Saw Ordering Replacement PartsParts Index No Description Size QtyIndex No. Part No Description Size Qty JBTS10MJS-49JBTS10MJS-105 JBTS10MJS-162 JBTS10MJS-224 Table Saw Page Mobile Stand JBTS10MJS-658 Wiring Diagram