Jet Tools JBTS-10MJS operating instructions JBTS10MJS-224

Page 35

Table Saw
Index No. Part No.		Description	Size	Qty
219	...............................	Miter Bar		1
220	JBTS10MJS-220	Label: Stand Set-Up/Storage & Warning		1
221	...............................	Fence Label: Direction Arrows		1
222	...............................	Fence Label: JET		1
223	JBTS10MJS-223	Motor		1
................	JBTS10MJS-223MB....	Motor Brush (not shown)		2
................	JBTS10MJS-223MBC ....Motor Brush Cover (not shown)			2
224	JBTS10MJS-224	Slide Base Assembly, Right		1
225	JBTS10MJS-225	Stop		1
226	JBTS10MJS-226	Hex Nut	9/16-18UNF	...............1
227	...............................	Blade Guard, Left Side		1
228	...............................	Location Pin		1
229	...............................	Washer	Ø5x16x2	1
230	...............................	Truss Head Round Neck Screw	M5x20	1
231	...............................	E-Clip	E-3	1
232	...............................	Cover		1
233	JBTS10MJS-233	Protective Strip		1
234	...............................	Cover Plate		1
235	JBTS10MJS-235	Shaft Assembly		1
236	...............................	Spring Pin	Ø3x18	1

35

Image 35

Contents Walter Meier Manufacturing Inc Benchtop Series Model No. JBTS-10MJSMore Information Warranty and ServiceTable of Contents Page Page Table Saw Safety Definitions and Terminology SpecificationsExtension Cords ElectricalGrounding Instructions Volt Operation OnlyFeatures FeaturesShipping Contents Hardware HardwareAttaching Saw to Stand AssemblyStand Rear Table Extension Mounting the Saw to Work SurfaceRemoving the Blade Installing the BladeHandwheel Handle Splitter riving knife installation Figure Blade Guard AssemblyBlade wrench Installing the Push-stick StorageStorage Rip fence and miter gaugeFolding the Stand AdjustmentsSetting up the Stand Adjusting the Table InsertAligning the Blade Guard Splitter Stop 45 Positive Stop AdjustmentAdjusting the Positive Stop Blade Tilt PointerBlade Parallel to the Miter Slot Additional Blade AdjustmentsRip Fence Adjustment Adjusting the Miter GaugeTable Extension Scale Pointer Rip Fence IndicatorRear Table Extension Adjustment Adjusting the Locking LeverBasic Saw Operations OperationUSE the TWO AT the Same Time Cutting OperationsBevel Crosscutting 0~45 Blade Level & 90 Miter Angle Ripping Small PiecesDado Cuts Using the Wood Facing on the Rip FenceInterfere with the cut if used on the left side groove Mitering 0~45 Miter AnglePage Lubrication MaintenanceBlade Raising and Tilting Mechanism Push Stick Construction Probable Cause Remedy TroubleshootingTrouble Index No Description Size Qty Ordering Replacement PartsParts Table SawJBTS10MJS-49 Index No. Part No Description Size QtyJBTS10MJS-105 JBTS10MJS-162 JBTS10MJS-224 Table Saw Page Mobile Stand JBTS10MJS-658 Wiring Diagram