Jet Tools JBTS-10MJS Installing the Push-stick Storage, Rip fence and miter gauge, Blade wrench

Page 16

Installing the Push-stick Storage

Attach the metal push-stick storage bracket (Figure 13) into the provided slot (D, Fig. 14) on the right side of the body shell. The bracket will snap into place.

Storage

Rip fence and miter gauge

Storage brackets for the rip fence (B, Fig. 14) and miter gauge (C, Fig. 14) are located on the right side of the saw housing.

Note: Adjust the miter gauge to 45º-60º before putting away in storage.

Blade wrench

Insert the handle of the blade wrench (A, Fig. 14) into the slot located to the right side of the saw housing.

Blade

1.Loosen and remove the knob (A, Fig. 15) on the left side of the saw housing.

2.Place extra blades (B, Fig. 15) onto the bushing. Replace the knob and tighten.

Figure 13

D

Figure 14

Figure 15

16

Image 16

Contents Benchtop Series Model No. JBTS-10MJS Walter Meier Manufacturing IncWarranty and Service More InformationTable of Contents Page Page Table Saw Safety Specifications Definitions and TerminologyElectrical Grounding InstructionsVolt Operation Only Extension CordsFeatures FeaturesShipping Contents Hardware HardwareStand AssemblyAttaching Saw to Stand Mounting the Saw to Work Surface Rear Table ExtensionHandwheel Handle Installing the BladeRemoving the Blade Blade Guard Assembly Splitter riving knife installation FigureInstalling the Push-stick Storage StorageRip fence and miter gauge Blade wrenchAdjustments Setting up the StandAdjusting the Table Insert Folding the StandAligning the Blade Guard Splitter 45 Positive Stop Adjustment Adjusting the Positive StopBlade Tilt Pointer StopAdditional Blade Adjustments Blade Parallel to the Miter SlotAdjusting the Miter Gauge Rip Fence AdjustmentRip Fence Indicator Rear Table Extension AdjustmentAdjusting the Locking Lever Table Extension Scale PointerOperation Basic Saw OperationsCutting Operations USE the TWO AT the Same TimeRipping Small Pieces Bevel Crosscutting 0~45 Blade Level & 90 Miter AngleUsing the Wood Facing on the Rip Fence Interfere with the cut if used on the left side grooveMitering 0~45 Miter Angle Dado CutsPage Blade Raising and Tilting Mechanism MaintenanceLubrication Push Stick Construction Trouble TroubleshootingProbable Cause Remedy Ordering Replacement Parts PartsTable Saw Index No Description Size QtyIndex No. Part No Description Size Qty JBTS10MJS-49JBTS10MJS-105 JBTS10MJS-162 JBTS10MJS-224 Table Saw Page Mobile Stand JBTS10MJS-658 Wiring Diagram