Jet Tools JWTS-10 operating instructions Handwheels, Extension Wings, Rear Guide Rail

Page 13

Handwheels

Referring to Figure 6:

The JWTS-10 Table Saw comes equipped with two handwheels which look identical except for the mounting holes as follows:

1.On the front of the table saw slide the bushing

(C)onto shaft (D) followed by the handwheel

(A)with the larger mounting hole, making sure to line up the flat side in the hole with the flat side on the shaft.

2.Fasten in place with lock knob (B).

3.Slide the remaining handwheel (D) with the smaller mounting hole onto the shaft (F) on the right side of the table saw, lining up the flat side in the hole with the flat side on the shaft.

4.Secure with an M5 lock washer (E) and M5x12 socket head cap screw (F).

Extension Wings

Referring to Figure 7:

1.Attach the right extension wing (A) to the table

(B)on the right side using four M8 hex cap screws (C) and four M8 lock washers (D). Hand-tighten only at this time.

2.Repeat for the left side.

Figure 6

Figure 7

Rear Guide Rail

Referring to Figure 8:

Required Fastening Hardware:

A – 1 ea – Rear Rail (Long)

H – 1 ea – Rear Rail (Short)

E – 6 ea – Hex Cap Screws (M8x20)

F – 6 ea – Lock Washers (M8)

G – 6 ea – Hex Nuts (M8)

Required Tools:

Two 12mm wrenches

1.Place the long rail (A) against the back of the right extension (B) and table (C). Line up the mounting holes.

2.Insert three hex cap screws (E) through the rail, extension and table.

3.Place lock washers (F) and hex nuts (G) on the threaded ends of the screws and hand-tighten only at this time.

4.Place the short rail (H) against the back of the table (C) and left extension (D). Line up the mounting holes.

Figure 8

5.Insert three socket head cap screws (E) through the rail; extension and table.

6.Place lock washers (F) and hex nuts (G) on the threaded ends of the screws and hand-tighten only at this time.

13

Image 13
Contents Table Saw Warranty and Service Table of Contents Page Error! Objects cannot be created from editing field codes Protection Tips from Kickback Kickback PreventionJWTS-10 Features SpecificationsDefinitions And Terminology Shipping Contents Hardware Tools Included for AssemblyAdditional Tools Required Unpacking and Cleanup AssemblyStand Assembly Blade Tilt Pointer Assembling the Saw to the StandExtension Wings HandwheelsRear Guide Rail Support Rod Front Guide RailExtension Wing Adjustment Switch BracketBlade Guard and Splitter Aligning the Blade Guard and Splitter Installing/Replacing the BladeRip Fence Table InsertOperation Miter GaugeElectrical Connections Grounding InstructionsExtension Cord Recommendations Adjusting 45º and 90º Positive Stops AdjustmentsBlade Raising and Tilt Mechanism Table Saws OperationsRip Sawing Resawing Bevel and Miter Operations Align-a-ripFeather Board Safety DevicesPush Stick & Push Block Filler PieceCleaning MaintenanceLubrication MiscellaneousSymptom Possible Cause Correction TroubleshootingParts JWTS-10 Table and Cabinet Parts ListJWTS-10 Table and Cabinet Exploded View Motor and Trunnion Assembly Parts List JWTS10-HP Motor and Trunnion Assembly Exploded View JWTS10-FA Fence and Rail Parts ListFence and Rail Exploded View Stand Assembly Parts List and Exploded View Wiring Diagram Electrical SchematicOrdering Replacement Parts Page WMH Tool Group