Jet Tools JWTS-10 operating instructions Resawing

Page 23

When ripping long boards, use a support at the front of the table, such as a roller stand, and a support or "tailman" at the rear as shown in Figure 30.

Never use the rip fence beyond the point where the carriage is flush with the end of the rails.

Have the blade extend about 1/8" above the top of the workpiece. Exposing the blade above this point can be hazardous.

Resawing

Resawing is a ripping operation in which thick boards are cut into thinner ones. Narrow boards up to 3" can be resawed in one pass. Wider boards up to 6" must be resawed in two passes.

In resawing wider boards, adjust the blade height so as to overlap the two cuts by 1/2" as shown in Figure 31. Too deep a first cut can result in binding and possible kickbacks on the second cut. Always use the same side of the board against the fence for both cuts.

Figure 31

Crosscutting

Crosscutting is where the workpiece is fed cross grain into the saw blade using the miter gauge to support and position the workpiece (Figure 31).

Figure 32

Crosscutting should never be done freehand nor should the fence be used as an end stop unless an auxiliary block is clamped to the front of the blade area such that the cutoff piece comes free of the block before cutting starts (Figure 33).

Figure 33

Length stops should not be used on the free end of the workpiece in the cutoff area.

Do not crosscut workpieces shorter than 6". Before starting a cut, be sure the miter gauge is securely clamped at the desired angle. Hold the workpiece firmly against the table and back against the miter gauge. Always use the saw guard and splitter and make sure the splitter is properly aligned.

For 90 degree crosscutting, most operators prefer to use the left-hand miter gauge slot. When using it in this position, hold the workpiece against the gauge with the left hand and use the right hand to advance the workpiece. When using the right hand slot for miter and compound crosscutting so that the blade tilts away from the gauge, the hand positions are reversed.

When using the miter gauge, the workpiece must be held firmly and advanced smoothly at a slow rate. If the workpiece is not held firmly, it can vibrate causing it to bind on the blade and dull the saw teeth.

Figure 34

23

Image 23
Contents Table Saw Warranty and Service Table of Contents Page Error! Objects cannot be created from editing field codes Protection Tips from Kickback Kickback PreventionJWTS-10 Features SpecificationsDefinitions And Terminology Shipping Contents Additional Tools Required Tools Included for AssemblyHardware Stand Assembly AssemblyUnpacking and Cleanup Blade Tilt Pointer Assembling the Saw to the StandRear Guide Rail HandwheelsExtension Wings Support Rod Front Guide RailBlade Guard and Splitter Switch BracketExtension Wing Adjustment Aligning the Blade Guard and Splitter Installing/Replacing the BladeRip Fence Table InsertOperation Miter GaugeExtension Cord Recommendations Grounding InstructionsElectrical Connections Blade Raising and Tilt Mechanism AdjustmentsAdjusting 45º and 90º Positive Stops Table Saws OperationsRip Sawing Resawing Bevel and Miter Operations Align-a-ripFeather Board Safety DevicesPush Stick & Push Block Filler PieceMiscellaneous MaintenanceCleaning LubricationSymptom Possible Cause Correction TroubleshootingParts JWTS-10 Table and Cabinet Parts ListJWTS-10 Table and Cabinet Exploded View Motor and Trunnion Assembly Parts List JWTS10-HP Motor and Trunnion Assembly Exploded View JWTS10-FA Fence and Rail Parts ListFence and Rail Exploded View Stand Assembly Parts List and Exploded View Wiring Diagram Electrical SchematicOrdering Replacement Parts Page WMH Tool Group