Jet Tools JWTS-10 operating instructions Maintenance, Cleaning, Lubrication, Miscellaneous

Page 27

Maintenance

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious personal injury.

Cleaning

Clean the JWTS-10 according to the schedule below to ensure maximum performance.

Note—The following maintenance schedule assumes the saw is being used every day.

Daily:

Wipe down the table surface and grooves with a rust preventive.

Clean the pitch and resin from the saw blade.

Weekly:

Clean the motor housing with compressed air.

Wipe down the fence rails with a dry silicon lubricant.

Lubrication

Lubricate the areas indicated below every 12 months.

Lubricate blade angling trunnions with 6 or 7 drops of light machine oil.

Lubricate the blade height trunnion with 6 or 7 drops of light machine oil.

Worm gears and threads should be lubricated with an automotive wheel bearing grease.

Check all adjustments after lubricating.

Miscellaneous

Always be aware of the condition of your machine. Routinely check the condition of the following items and repair or replace as necessary:

Mounting bolts

Power switch

Saw blade

Blade guard

27

Image 27
Contents Table Saw Warranty and Service Table of Contents Page Error! Objects cannot be created from editing field codes Protection Tips from Kickback Kickback PreventionJWTS-10 Features SpecificationsDefinitions And Terminology Shipping Contents Tools Included for Assembly HardwareAdditional Tools Required Assembly Unpacking and CleanupStand Assembly Blade Tilt Pointer Assembling the Saw to the StandHandwheels Extension WingsRear Guide Rail Support Rod Front Guide RailSwitch Bracket Extension Wing AdjustmentBlade Guard and Splitter Aligning the Blade Guard and Splitter Installing/Replacing the BladeRip Fence Table InsertOperation Miter GaugeGrounding Instructions Electrical ConnectionsExtension Cord Recommendations Adjustments Adjusting 45º and 90º Positive StopsBlade Raising and Tilt Mechanism Table Saws OperationsRip Sawing Resawing Bevel and Miter Operations Align-a-ripFeather Board Safety DevicesPush Stick & Push Block Filler PieceMiscellaneous MaintenanceCleaning LubricationSymptom Possible Cause Correction TroubleshootingParts JWTS-10 Table and Cabinet Parts ListJWTS-10 Table and Cabinet Exploded View Motor and Trunnion Assembly Parts List JWTS10-HP Motor and Trunnion Assembly Exploded View JWTS10-FA Fence and Rail Parts ListFence and Rail Exploded View Stand Assembly Parts List and Exploded View Wiring Diagram Electrical SchematicOrdering Replacement Parts Page WMH Tool Group