Jet Tools JWTS-10 operating instructions Front Guide Rail, Support Rod

Page 14

Front Guide Rail

Referring to Figure 9:

Required Fastening Hardware (see also inset):

A – 6 ea – Square Head Bolt (M8)

B – 6 ea – Lock Washer (M8)

C – 6 ea – Hex Nuts (M8)

Required Tools:

12mm wrench

1.Place six square head bolts (A) through the mounting holes on the front of the left extension (F), table (G) and right extension (H).

2.Place lock washers (B) and hex nuts (C) on the threaded ends of the bolts protruding through the extensions and table. Just start the hex nuts but do not tighten.

3.Position all six bolts so that approximately 1/4" of thread is visible between the bolt heads and extensions/table (J).

4.Slide the short rail (D) onto the front edge of the extension and table from left to right (K). The back edge of the rail should make contact with the front edge of the extension and table and the square head bolts should slide into the groove on the back side of the rail.

5.In the same manner described in step 4, slide the long rail (E) onto the front edge of the extension and table from right to left (L).

6.Slide the short and long rail sections together so they become one piece. The protruding pins from the short rail should insert into the corresponding openings in the long rail.

7.Position the entire rail assembly so the left end of the rail is about 0.75” in from the edge of the left extension.

8.Hand-tighten only the hex nuts (C) that secure the front rail to the table.

Support Rod

Referring to Figure 10:

1.Place the tenon end (A) of the support rod into the slot (B) of the front rail.

2.Secure the tapped and threaded end (C) of the support rod to the rear rail (D) with the M6 flat washer (E) and M6 hex cap screw (F) provided.

14

Figure 9

Figure 10

Image 14
Contents Table Saw Warranty and Service Table of Contents Page Error! Objects cannot be created from editing field codes Kickback Prevention Protection Tips from KickbackFeatures Specifications JWTS-10Definitions And Terminology Shipping Contents Additional Tools Required Tools Included for AssemblyHardware Stand Assembly AssemblyUnpacking and Cleanup Assembling the Saw to the Stand Blade Tilt PointerRear Guide Rail HandwheelsExtension Wings Front Guide Rail Support RodBlade Guard and Splitter Switch BracketExtension Wing Adjustment Installing/Replacing the Blade Aligning the Blade Guard and SplitterTable Insert Rip FenceMiter Gauge OperationExtension Cord Recommendations Grounding InstructionsElectrical Connections Blade Raising and Tilt Mechanism AdjustmentsAdjusting 45º and 90º Positive Stops Operations Table SawsRip Sawing Resawing Align-a-rip Bevel and Miter OperationsSafety Devices Feather BoardFiller Piece Push Stick & Push BlockLubrication MaintenanceCleaning MiscellaneousTroubleshooting Symptom Possible Cause CorrectionJWTS-10 Table and Cabinet Parts List PartsJWTS-10 Table and Cabinet Exploded View Motor and Trunnion Assembly Parts List JWTS10-HP Motor and Trunnion Assembly Exploded View Fence and Rail Parts List JWTS10-FAFence and Rail Exploded View Stand Assembly Parts List and Exploded View Electrical Schematic Wiring DiagramOrdering Replacement Parts Page WMH Tool Group