Jet Tools JWTS-10 operating instructions Miter Gauge, Operation

Page 18

This fence is positioned by lifting up the lock handle (A, Fig. 19) and sliding to the desired location. "Fine-tuning" is accomplished by pushing the micro-adjust knob in (B, Fig. 19) and at the same time turning it (C, Fig. 19) until the exact position is read on the scale.

Miter Gauge

Operation

Referring to Figure 20:

Operate the miter gauge by loosening the lock knob (A) and turning the miter body (B) to the desired angle.

The pin (C) functions as an index stop. When pushed in, the body will stop at -45º, 90º or +45º when turned as one of three screws (D) located underneath the miter hits the pin.

Calibration

If a miter angle at the -45º, 90º or +45º is not correct, the index stops can be adjusted by turning one of three adjustment screws (D), then locking the hex nut.

Note: Always make test cuts. Do not rely solely on miter gauge indicator marks.

18

Figure 19

Figure 20

Image 18
Contents Table Saw Warranty and Service Table of Contents Page Error! Objects cannot be created from editing field codes Kickback Prevention Protection Tips from KickbackFeatures Specifications JWTS-10Definitions And Terminology Shipping Contents Tools Included for Assembly HardwareAdditional Tools Required Assembly Unpacking and CleanupStand Assembly Assembling the Saw to the Stand Blade Tilt PointerHandwheels Extension WingsRear Guide Rail Front Guide Rail Support RodSwitch Bracket Extension Wing AdjustmentBlade Guard and Splitter Installing/Replacing the Blade Aligning the Blade Guard and SplitterTable Insert Rip FenceMiter Gauge OperationGrounding Instructions Electrical ConnectionsExtension Cord Recommendations Adjustments Adjusting 45º and 90º Positive StopsBlade Raising and Tilt Mechanism Operations Table SawsRip Sawing Resawing Align-a-rip Bevel and Miter OperationsSafety Devices Feather BoardFiller Piece Push Stick & Push BlockLubrication MaintenanceCleaning MiscellaneousTroubleshooting Symptom Possible Cause CorrectionJWTS-10 Table and Cabinet Parts List PartsJWTS-10 Table and Cabinet Exploded View Motor and Trunnion Assembly Parts List JWTS10-HP Motor and Trunnion Assembly Exploded View Fence and Rail Parts List JWTS10-FAFence and Rail Exploded View Stand Assembly Parts List and Exploded View Electrical Schematic Wiring DiagramOrdering Replacement Parts Page WMH Tool Group