Wolfcraft 4525 manual Unpacking and Checking Contents, Introduction, Assembling Your Drill Guide

Unpacking and Checking Contents

Separate all parts from the packing materials and check them against the illustration and the “Table of Parts.” Make sure all parts are accounted for before discarding any of the packing material.

Figure 1	L
	L
	A
	A

C

			B
	K			M
			K
	D
	E
			E
	F
			G
	I		I
	J	H	J
				FIG 1
	TABLE OF PARTS
ITEM	DESCRIPTION			QTY.
A	Guide Bar/Spring Assembly			2
B	Cross Guide/Chuck Assembly 1
C	Thumb Screw			1
D	Depth Stop			1
E	Bar Holder			2
F	Base Plate			1
G	Handle			1
H	Nut			1
I	Supports			2
J	Hex Screw			2
K	Springs			2
L	Caps			2
M	Chuck Key			1

Introduction

Precision hole drilling and countersinking is a skill that ordinarily takes years to acquire. Yet the success of many projects depends on drilling straight, accurate holes.

Your wolfcraft Drill Guide, when used with your power drill, makes it easy to perform many precision operations, including straight and angled drilling, edge and round stock drilling, countersinking and edge sanding. It provides you with better control for a better finished result.

You can use your wolfcraft Drill Guide any- where you need a drill—even in masonry or concrete using the proper bit.

Assembling Your Drill Guide

(See Figure 1)

WARNING You must read and understand all the instructions of your Drill

Guide as well as your drill owner’s manual before attempting to assemble and operate this product.

1.Secure handle (G) to base plate (F) with nut

(H). The ribs in base plate will hold nut in position while tightening handle.

2.Remove springs (K) from both guide bars

(A). Slide guide bars into cross guide/chuck assembly (B). Position springs back on guide bars.

3.Thread thumb screw (C) into cross guide/chuck assembly.

4.Slide depth stop (D) onto guide bar under thumb screw in cross bar/chuck assembly. Position thumb screw on depth stop facing out.

5.Place bar holders (E) on guide bars. Rotate bar holders so index marks are facing out.

6.Install hex screw (J) through each support

(I). Position guide bars on base plate with tabs on bar holders passing through slots in base plate. Hold guide bars vertical and install supports. Rotate caps (L) clockwise on top of guide bars to tighten screws.

3