Wolfcraft 4525 manual Workbench Mounting Only for Edge Sanding, Repair Parts

Workbench Mounting Only - for Edge Sanding

1.Use a hole saw to cut a hole no larger than 2 1/4" in the top of your workbench.

2.Center the Drill Guide base around the hole on the underside of the bench. Push rubber stopper pieces out. Secure base to the bench using four 1/4" flat head screws through holes provided in base (screws not included). (See Figure 11.)

3.To keep the bit locked in place, adjust the bit above the bench surface to the desired position. Tighten the thumb screw in the cross guide/chuck assembly.

NOTE: With this type of mounting, it is recom- mended having a material guide or straight edge secured to the top the bench.

Figure 11

Edge Sanding

For edge sanding, the Drill Guide can either be handheld or mounted under the workbench. (See Figure 12.)

Figure 12

Repair Parts

Figure 13 1

102

			3
			4
			5
	20		7
			5
	11		3
			8
	6			19
			11
		9
	12
	13
			13
			14
	21		21
	17			15
	18		17
	21	16	18
KEY				FIG 13
NO.	PART NO.	DESCRIPTION		QTY
1	116600036	Rod Cap		2
2	117220130	Shaft		1
3	116700029	Retaining Ring		2
4	116710120	Washer		1
5	117110002	Sleeve Bushing		2
6	116710067	Thumb Screw M6 x 16		1
7	116410022	Cross Guide		1
8	015100033	Chuck		1
9	116800011	Countersunk Screw		1
10	117200008	Guide Bar		2
11	117610002	Spring		2
12	116600085	Depth Stop		1
13	116600034	Bar Holder		2
14	116430120	Base Plate		1
15	116610051	Handle		1
16	116700023	Hex Nut		1
17	116600033	Support		2
18	116700055	Hex Screw		2
19	015100034	Chuck Key		1
20	116620052	Thumb Screw M6 x 10		1
21	117720017	Rubber Stop		4

6