Angle Drilling
Loosen caps on both guide bars (See Figure
5)and rotate guide bars to align the index mark on both bar holders to the desired angle (See Figure 6) reference marks on the base plate. Tighten caps and drill the hole with the Drill Guide flush with the work piece. (See
Figure 7.)
Figure 5
Figure 6
0˚ - 45˚0˚ - 45˚
FIG 5
Figure 7
Edge Drilling
Place the Drill Guide on the edge of the work piece to be drilled. (See Figure 8.) Rotate the base plate clockwise until sides of work piece contact the base plate. (See Figure 9.) The drill is now centered on the edge.
Figure 8
A
A
A
A
FIG 10
Figure 9
A
Round Stock Drilling
Figure 10
5