Wolfcraft 4525 Attaching and Removing Your Drill, Operating Instructions, Setting Depth of Hole

Attaching and Removing Your Drill

Figure 3

Before using, attach your drill to shaft using a chuck key. (See Figure 2.) When completing a drilling project, remove drill from the drill guide.

Figure 2

CHUCK KEY

Operating Instructions

Do not use Drill Guide as a router. The base plate must be secured when drilling round stock and holes.

Setting Depth of Hole

The depth stop feature controls depth with repeated accuracy. When operating your Drill Guide using the depth stop feature, remove springs from both guide rods.

1.Place the drill guide at the edge of your workbench.

2.Press the drill down until the desired depth of the hole is reached. (See Figure 3.) Tighten the thumb screw in the cross guide/chuck assembly.

3.Slide the depth stop against the cross bar/ chuck assembly.Tighten the depth stop thumb screw. Release the thumb screw in cross guide/chuck assembly.You are ready to drill.

90° Drilling

To drill a hole straight down, 90° angle to the work piece, loosen both guide bars (See Figures 4 and 5) and rotate them to align index mark on both bar holders with 0 marks on the base plate. Tighten guide bars in posi- tion. Place the Drill Guide flush with the work piece before drilling.

Figure 4

Countersink

Install a countersink bit in the chuck. Adjust the depth stop to desired countersink depth.

4