Delta 20-330 Assembling Stand Handle, Assembling Stock Advance Stop, Assembling Guard and Belt

Page 10

ASSEMBLING STAND HANDLE

Insert ends of handle (A) Fig. 5, into the two holes (B) on the right leg and fasten in place using the two cotter pins supplied.

ASSEMBLING STOCK ADVANCE STOP

Assemble the stock advance stop assembly (A) to the hole on the front of the table and tighten the two set screws (B), as shown in Fig. 6.

ASSEMBLING GUARD AND BELT

Open the belt and pulley guard (A) Fig. 7, and position the bottom half of the guard assembly behind the pulleys (B) as shown. Line up the two holes in the bottom of the guard with the two threaded holes in the casting. NOTE: DO NOT COMPLETELY TIGHTEN THE

PULLEY GUARD TO THE CASTING AT THIS TIME. Place a 1/4" flat washer onto a 1/4-20x1/2" hex head screw and insert screw through hole in pulley guard and thread screw into the tapped hole in the casting. Repeat this process for the remaining hole. Raise the motor and assemble the belt (D) Fig. 7, to the desired steps of the two pulleys then release the motor. A speed selection chart (E) is located on the inside of the guard cover. When the belt is tensioned, tighten screws (C).

FASTENING BAND SAW TO

SUPPORTING SURFACE

IF DURING OPERATION THERE IS ANY TENDENCY FOR THE BAND SAW TO TIP OVER, SLIDE OR WALK ON THE SUPPORTING

SURFACE, THE RIGHT LEG OF THE BAND SAW MUST BE SECURED TO A SUPPORTING SURFACE.

Align the hole in the “L” shaped floor mounting bracket

(A)Fig. 8, with the hole in the bottom of the right leg (B). Insert a 5/16” flat washer (C) onto a 5/16-18x1/2” hex head screw (D). Insert screw through the floor mounting bracket (A) and the right leg. Place a 5/16” flat washer

(E)onto the screw (D) and tighten securely. Repeat this process for the remaining hole on the other side of the right leg. Then secure the two brakcets to the supporting surface.

B

A

Fig. 5

A

B

B

Fig. 6

A

E

D

C

B

Fig. 7

B

A

F

C

E

D

Fig. 8

10

Image 10
Contents 6 Horizontal Band Saw Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Manual Before Operating the MachineAdditional Specific Safety Rules Failure to Follow These Rules MAY Result in Serious InjuryMotor Specifications Power ConnectionsGrounding Instructions Extension Cords Functional DescriptionForeword Carton Contents AssemblyAssembling Wheels Assembling StandAssembling Vise Handwheel Assembling Guard and Belt Assembling Stand HandleAssembling Stock Advance Stop Fastening Band SAW to Supporting SurfaceOperation Locking Switch in OFF PositionAdjusting Blade Tension Starting and Stopping MachineAdjusting Blade Tracking Adjusting Blade Support BearingsAdjusting Blade Guide Bearings Adjusting Blade 90 Degrees to the Table SurfaceAdjusting Feed Rate Adjusting Blade Guide BracketsOperating Adjusting the Vise Changing Speeds Adjusting Belt Tension Adjusting Stock StopARM Positioning Lever Speed and Material Chart Blade SelectionChanging Band SAW from Horizontal to Vertical Position Typical Operations for Vertical Band SAW Changing BladesTypical Operations for Horizontal Band SAW Cutting CurvesTroubleshooting Probable Cause RemedyTrouble Blade will not Track Band SAW Blades Maintenance Accessories ServiceWarranty Canadian PORTER-CABLE Delta Service Centers