Delta 20-330 instruction manual Assembling Stand, Assembling Wheels, Assembling Vise Handwheel

ASSEMBLING STAND

1.Assemble the two legs (A) and (B) Fig. 2, to the band saw base using the six 5/16-18x1" hex head cap screws, three of which are shown at (C) Fig. 2, twelve 5/16" flat washers and six 5/16-18" hex nuts. Align the holes in the band saw with the holes in the legs. Place a 5/16" flat washer onto a 5/16-18x1" hex head cap screw, insert screw through the hole in the band saw and the hole in the leg, place a 5/16" flat washer onto the screw, thread a 5/16" hex nut onto the screw, and tighten securely. Repeat this process for the five remaining holes.

2.Assemble the shelf (D) Fig. 2, to the two legs (A) and

(B). Align the four holes in the shelf (D) with the four holes in the two legs (A) and (B). Insert a M6x10mm hex head screw, two of which are shown at (E) through the hole in the shelf and leg. Place a 6mm lockwasher onto the screw, thread a M6 hex nut onto the screw, and tighten securely. Repeat this process for the three remaining holes.

C

B

A

C E

D

Fig. 2

ASSEMBLING WHEELS

Assemble the wheel assembly (A) Fig. 3, to the bottom of the left leg. Align the holes in the wheel assembly with the holes in the left leg. Place a 1/4" flat washer onto a 1/4-20x1/2" hex head screw, insert the screw through the holes (B) in the wheel assembly and the hole in the left leg, place a 1/4" flat washer onto the screw, thread a 1/4-20 hex nut onto the screw, and tighten securely. Repeat this process for the remaining hole.

B

A

Fig. 3

ASSEMBLING VISE HANDWHEEL

Assemble the vise clamping handwheel (A) Fig. 4, to the shaft (B), and tighten set screw (C) against the flat on the shaft (B).

A

B

C

Fig. 4

9