Delta 20-330 instruction manual Changing Band SAW from Horizontal to Vertical Position

CHANGING BAND SAW FROM HORIZONTAL TO VERTICAL POSITION

Your saw can be changed to the vertical position for notching, slitting or contour work as follows:

DISCONNECT MACHINE FROM

POWER SOURCE.

1.Move the cutting arm to the vertical position and lock in place with the arm positioning lever (C) Fig. 32. Stop screw (A) Fig. 32 should bear against base casting when arm is in the vertical position. If adjustment is needed loosen lock nut (B) and adjust screw (A).

2.Remove two screws (C) and bearing cover plate (D) Fig. 33.

3.Assemble the vertical table (E) to the guide bracket using the two screws (C) that were removed in STEP 2, as shown in Fig. 34.

4.Assemble one end of the table support bracket (G) Fig. 35 to the table using a 1/4-20x1/2" flat head screw and 1/4-20 nut (H) and the other end underneath the guide bracket lock knob (J), as shown in Fig. 35.

C

B

A

Fig. 32

D

C

C

Fig. 33

C

E

Fig. 34

H

J

G

Fig. 35

17