5. GUI Installation and Operation
Using the Video Switching Tab
`äÉ~êáåÖ=~=oçìíÉ
The “clear” procedure enables you to clear (or “blank”) a route.
On the Video Switching Tab, use the following steps to clear a route:
1.In the Outputs Section, click the output channel that you want to clear. The button lights yellow along with its currently assigned input.
2.In the Inputs Section, click the currently assigned input button. In the video column, the label
3.Click TAKE. The selected input button turns off, indicating that the input has been cleared and the output channel has been blanked.
Note
You can perform a
rëáåÖ=od_=jìíÉ
The RGB Mute feature enables you to blank a channel’s output video while leaving the channel’s sync signals running to the monitor.
On the Video Switching Tab, use the following steps to “mute” an output:
1.Verify that an active route is in place (based on a bright green square in the Video column) for the selected output.
2.In the Outputs Section, enable the check box in the RGB Mute column for the output that you wish to mute. The channel is immediately muted — pressing TAKE is not required.
3.Repeat from step 1 to mute another output channel.
Please note the following important points:
•To clear an RGB Mute route, simply disable the check box.
MatrixPRO • 8x8 DVI Router • User’s Guide |
| 67 |
|