Barco 26-0503000-00 manual ~íêáñmol léÉê~íáåÖ=mêçÅÉÇìêÉë, MÉêÑçêãáåÖ=~=q~âÉ=======

4. Operation

MatrixPRO Operating Procedures

j~íêáñmol léÉê~íáåÖ=mêçÅÉÇìêÉë

The following operating procedures are covered in this section:

•

•

•

•

•

•

•

•

Performing a Take Performing a Multi-Take Clearing a Route Checking Router Status Routing a Test Pattern Using RGB Mute Working with Groups Unlocking the Control Panel

mÉêÑçêãáåÖ=~=q~âÉ=======

„Use the following steps to perform a take:

1.In the Output Selection Section, select the output channel (destination) to which you want to route an input. Please note:

~If an input is already associated with that output on a completed route, the input button lights steady.

~If an input is already associated with that output on a pending route, the input button blinks.

~If there is no input associated with the output, the output is “blanked” and no input buttons will light.

2.In the Input Selection Section, select a new input source. The selected (pending) input button blinks.

3.Press TAKE. The selected input button lights steadily, and the Status Menu updates accordingly.

4.Repeat from step 1 to perform another take.

Please note the following important points:

•To cancel a route before pressing TAKE, press ESC, or press the blinking input button to “de-select” it. The previous route remains in effect.

•A “pending” route remains pending — even if you switch to a different output — until TAKE or ESC is pressed. This rule applies to channel routes, test pattern routes, and RGB Mute routes.

S If you pend a route to output 1 (e.g., input 5 to output 1), then you switch to output 2, and then you switch back to output 1 — the selected route is still pending (and input 5 will still be blinking).

48 MatrixPRO • 8x8 DVI Router • User’s Guide