UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 16 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
PRODUCT FEATURES
FIGURE E |
| SIDE HANDLE | LUBRICATING | |||||
|
| |||||||
|
|
|
|
| ||||
|
|
|
|
| UNIT KNOB | |||
| POWER SWITCH |
|
|
|
|
|
| WAX TUBE |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||
|
|
|
|
|
| |||
|
| HOUSING | |||
POWER |
|
|
|
| LOWER GUARD |
|
|
|
| ||
|
|
|
|
| |
CORD/PLUG |
|
|
|
|
|
UPPER GUARD
1.Power Switch: The Power Switch is a simple “slider” switch that when pressed and held turns on the Twin Cutter Saw. To turn off the Saw, release pressure on the Power Switch and the switch will automatically return up to its “OFF” position.
2.Power Cord/Plug: The Power Cord/Plug must only be connected to a 120 volt, grounded, electrical outlet. Do not pull on the Cord to remove the Plug from its electrical outlet.
3.Side Handle and Housing: The Side Handle allows for increased control of the Twin Cutter Saw and additional safety. When using the Saw, always maintain a firm grip on the Side Handle and Housing.
4.Lower Guard and Upper Guard: Before each use of the Twin Cutter Saw, always check to make sure the Lower Guard and Upper Guard are operating properly. Also, make sure the Saw Blades do not touch either Guard.
5.Wax Tube and Lubricating Unit Knob: Always use a lubricating Wax Tube when cutting aluminum, copper, stainless steel, and cast iron. When cutting, these materi- als tend to soften and adhere to the Saw Blades and can diminish the performance of the Twin Cutter Saw. To use a Wax Tube, insert the Wax Tube into the Lubricat- ing Unit Dispenser. Turn the Lubricating Unit Knob to apply lubricant to the Saw
SKUs | 94596 & | For technical questions, please call | Page 12 |
| 94896 |
|
|